2000 Ford Excursion Limited Sport Utility 4-door 6.8l No Reserve on 2040-cars

Auto blog

How the 2015 Ford Mustang will save your knees

The 2015 Mustang is one of the most hotly anticipated vehicles of the moment, and Ford continues to leak out interesting little details about its newest pony car. The latest info doesn't have anything to do with its quarter-mile time or handling, but if any of that goes drastically wrong, the innovative new glovebox-mounted airbag may prevent passengers from knee injuries.
All variants of the 2015 Mustang get the active knee airbag as standard, and it's the first vehicle in Ford's lineup to receive the system. The setup is actually quite simple and ingenious. The glovebox is made from a plastic outer panel that is attached to the inner door. Sandwiched between them is this new injection-molded plastic bladder that folds flat when in use. If the passenger-side airbag deploys, the system springs into action to act as a cushion for your knees. Compared to a traditional knee airbag that has to fully inflate, this arrangement is 65 percent lighter and can use a 75 percent smaller inflator. It's also basically invisible when you look at the glovebox door.
Ford spokesperson Ed Saenz declined to tell Autoblog whether the system will appear in other vehicles in the Blue Oval's lineup but said, "We're considering other applications." Provided it's effective, the approach seems too simple not to make its way to other products. Scroll down to watch a video showing how the glovebox-mounted knee airbag works.

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.