02 Ford Excursion Limited No Reserve 7.3 Diesel Powerstroke Rare on 2040-cars

Auto blog

Ford F-250 boots Cadillac Escalade from atop thieves' most-wanted list

The Ford F-Series has been America's best-selling truck for decades, but along with the good comes the bad, apparently. In addition to being popular with consumers, the Highway Loss Data Institute notes that the F-Series Super Duty has risen in popularity among thieves. Based on its new study, the four-wheel drive crew cab F-250 Super Duty has topped the list for the country's highest rate of insurance theft claims, knocking the Cadillac Escalade from the top spot - a distinction the luxury SUV has held since this annual report was first established in 2003.
To reach its findings, HLDI looks at theft data from the previous three model years (in this case 2010-2012) to determine the frequency of claims for a particular make and mode,l as well as the average payment per claim. As the report points out, the claims aren't always for the theft of the entire vehicle - they can include components (say, wheels and tires) or property taken from the vehicle. At seven claims per 1,000 insured vehicles, the F-250 is six times more likely to suffer a theft claim than the average vehicle.
The Cadillac likely dropped from the top of the list to sixth due to additional theft-prevention features including a steering wheel lock and inclination sensor for the alarm, but GM's other fullsize trucks and SUVs still occupy eight of the list's 10 spots. Some of the least stolen vehicles with below-average loss payments include the Lexus HS250h, Hyundai Tucson, Honda CR-V and Dodge Journey. Head on over to the HLDI's website for the full list that shows the most and least popular vehicles among thieves from 2010 through 2012.

Mustang parts under the new Lincoln Aviator mean good things for Ford

NEW YORK — As we mentioned last night, underneath the new Lincoln Aviator "concept" there appears to be an independent rear suspension lifted right from the Ford Mustang parts bin. And while it's pretty cool on its face that Mustang rear-drive platform bits are being reused in the broader Ford universe, what this means for the next Explorer could be really cool. A quick caveat: The Aviator here in New York is very close to the production version, but it's not technically a production car. It looks hand-built, with temporary exhaust and some show-car touches. The suspension underneath looks exactly like a Mustang's, but the actual production Aviator will almost certainly use beefier components with the same basic design and geometry, since the Aviator will be much heavier than the smaller Mustang. That being said, we're fairly confident that even at this early stage, the Mustang-derived suspension seen in New York is a preview of what'll be under the production Aviator. Furthermore, Ford won't say it, but based on what we're seeing on Aviator, it's a safe bet that Ford will utilize the Aviator platform for the next Explorer. That would enable the economies of scale necessary to produce a brand new rear-drive-based SUV platform in the first place. It also means that the Explorer should be available without AWD — and given the stable of powerful EcoBoost engines, and the competent 10-speed automatic in the parts bin, a rear-drive Explorer has a shot at being a decent driver. Aviator wouldn't go rear-drive-based if driving dynamics weren't important; Explorer should inherit these priorities. More evidence: The Explorer spy shots we saw back in February sure share the Aviator's general proportions. Even back then, before Aviator was revealed, we were hypothesizing that an EcoBoost 3.5-liter-powered version could boast as much as 400 horsepower, if the Expedition's tune were adopted. Suddenly, the Explorer seems very interesting. So, an EcoBoost, rear-drive Explorer sure sounds like something Ford Performance would be interested in, right? We knew an Explorer ST is coming, but with 365-400 horsepower potential and a chassis designed with dynamics in mind, it doesn't seem like as much of a stretch as the Edge ST. And a performance-oriented AWD system is a possibility, too. That's an area where Ford has been gathering experience at a rapid pace. What do we not expect from a new Explorer? A V8.

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.