2010 Ford E-250 Base Extended Cargo Van 3-door 4.6l on 2040-cars

Auto blog

Old vs. new debate gets new life with $25,000 Fiesta ST vs. E46 M3 showdown

You know who you are. There's probably a few of you reading; the ones that say, "Why would I spend $27,000 on a new Mazda MX-5 when I could get a used Chevrolet Corvette with more power." Yes, we're talking to you, used car proponents. While it is a fair argument, it's not like used cars don't come with drawbacks of their own, though.
In an attempt to put this new-versus-used argument to bed once and for all, Matt Farah of the The Smoking Tire has picked up a pair of $25,000 cars - a used, but lightly modified, 2003 BMW M3 and a 2013 Ford Fiesta ST. Naturally, there's a comparison.
Farah, as he's wont to do, does get into the nitty gritty of what each car is like to drive, and discusses the merits of used and new-car shopping. But as he rightly points out while testing the M3, "So, it is a good car. But like any used car, it really does depend on the individual car."

2017 Honda Ridgeline enters the landscape block war

In the test of pickup truck beds, if steel is apples and aluminum is oranges, Honda wants you to know that composites are pineapples. Chevy recently performed a test in which its own Silverado was pitted against its most obvious competitor, the Ford F-150. A loader dropped over 800 pounds of landscaping blocks into the two truck beds, and Ford's aluminum bed ended up with more damage than Chevy's steel bed. Check that test out right here. Honda apparently wasn't content to let Chevy throw stones alone. In a new test, the Japanese automaker replicated the block-drop test using its brand-new Ridgeline truck, which features a composite bed. As you'll see in the video above, there was very little damage to the high-strength plastic bed of the Ridgeline after a similar load of landscaping blocks were dropped from a loader. Without being on hand at any of these tests, we can't say with any degree of certainty that they match up in severity. But they all look pretty similar, and this is actually a test that Honda performed in front of journalists ( ourselves included) earlier this year. We visually inspected the composite bed of a Ridgeline after a demonstration just like the one on video above, and can confirm that there was basically no damage to Honda's truck. Chevy went an extra step by flinging a heavy toolbox into the Silverado and F-150; Honda didn't match that particular test. Does any of this matter? That's up to truck buyers and owners to decide, naturally, but we doubt anyone would actually dump a load like this into their own truck. And it's also worth noting that a heavy-duty spray-on bedliner would probably minimize damage to the metal surface below, whether steel or aluminum. If nothing else, it's memorable marketing. Related Video:

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.