1991 Ford E-series Van Econoline Xlt on 2040-cars

Auto blog

William Clay Ford Sr. dead at 88

William Clay Ford, retired vice chairman of Ford Motor Company and the last surviving grandchild of company founder Henry Ford, died this morning after a bout with pneumonia. He was 88.
Ford spent 57 years with his grandfather's company, joining the board of directors in 1948 before graduating from college. Ford also held a position as chairman of the design committee, as well as the chairman of the executive committee and vice chairman of the Board of Directors during his tenure with the company. In a 2013 Detroit Free Press story, retired CFO Allan Gilmour said Ford had an eye for design, and was once able to pick out when a fiberglass model of a Ford Contour was asymmetrical, off by an inch on one side. He retired and assumed the position of director emeritus in 2005.
"My father was a great business leader and humanitarian who dedicated his life to the company and the community," said Bill Ford, Jr., Ford's current executive chairman. "He also was a wonderful family man, a loving husband, father, grandfather and great-grandfather. He will be greatly missed by everyone who knew him, yet he will continue to inspire us all."

Auto critic calls out Corvette, Mustang and Cherokee faithful

Most automotive purists fear change, but not without reason. Change, after all, did kill big-block V8s, along with most station wagons and manual transmissions. But change has also brought with it far more performance, safety and fuel economy - not to mention ridding the world of shag carpet interiors, bias-ply tires and those horrible motorized seatbelts of the early '90s.
By this time next year, the Chevy Corvette, Jeep Cherokee and next-generation Ford Mustang will all be on sale and will all, in some way, have angered or offended purists. To those critics, Mark Phelan of the Detroit Free Press is preemptively telling them to stop complaining - at least until they've all been driven. From the Corvette's square taillights and the Cherokee's radical nose to whatever pony car purists will harp on the 2015 Mustang for, Phelan's column points out the positives of automotive evolution and the negatives of staying the course for too long. That's fair enough, but do you think Phelan is on point, or all wet? Head on over to the Detroit Free Press to read his words, then have your say in Comments.

Toyo Tires will bring another wild catalog of rides to SEMA

Toyo Tires carts all kinds of toys to SEMA every year, the rubber company planning another 30 or so automotive exhibits this year in two locations. One of them, the Baja 911, comes with a pedigree not usually associated with the bewildering wares hawked at the Las Vegas show. TJ Russell was once lead fabricator for Singer Vehicle Design, now he's the head of Russell Built Fabrication in Sun Valley, CA. Sticking with the marque he knows well, Russell started with a 1991 Porsche Carrera 4 cabriolet, fitted the interior with a full roll cage, then built a hardtop around it to design a desert runner channeling the old Rothmans safari 911s. Underneath that bodywork lives a box-plate trailing arm suspension with 12 inches of travel, working 15-inch Fifteen52 FIA-approved Gravel wheels and 30-inch Toyo Open Country A/T II tires. Power comes from a purpose-built 3.8-liter air-cooled flat-six with about 350 horsepower — 100 hp more than stock — in a car that weighs 400 pounds less than the original. Oh, and as documented on Instagram with the tagline "All race outside, all business inside," the interior's full of quilted, cross-stitched leather, and Toyo says Russell's going to do a low-volume run of the Baja 911 starting early next year. ruffian-ford-mustang-sema-01 View 10 Photos Chris Ashton built a 1970 Ford Mustang Fastback called the Ruffian Mustang, inspired by the Trans Am Racing Series. The exterior changes are more subtle than one might think – the chin spoiler, hood scoop, and side mirrors are barely exaggerated versions of those on the original car, the intake vents astride the front lights and the steel bumpers teleported from 1970. Changes outside include de-chromed and flush-mounted glass, vented hood, front fenders that are dropped an inch, rear fender vents, dual side-exit pipes, and gargantuan fender flares over staggered Signature One wheels and Toyo Proxes 888 tires. The interior's fitted with a roll cage and race car workings. In spite of the Boss 427 badging, the engine's a 625-hp Chevrolet LS3 V8. button-built-ferrari-355-sema-01 View 13 Photos The Button Built Ferrari BB355TT picks up from last year's stanced BB328GTS widebody that gave many Internet denizens heart attacks. Laid up on a 1999 355 Berlinetta, the BB version appends a widebody kit designed Mitchell Button, rendered by Khyzyl Saleem and drenched in Azzuro la Plata, a color from Ferrari's Scagliette palette first used on a 1967 275GTB Le Mans racer.