2000 Ford Contour Svt Sedan 4-door 2.5l on 2040-cars

Auto blog

Mustang Cobra Jet prototype garners $200k for charity at Barrett-Jackson

A few weeks ago we brought you news of a one-off Mustang Cobra Jet that Ford was donating to charity. The car was set to be auctioned off by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society. Now that auction has taken place, bringing in an impressive $200,000 for MS research.
That's a lot of zeros for a Mustang, much less one you can't even drive on the street. But the unique pony car, bearing serial number 2014 BJMS CJXX1, packs a 5.0-liter supercharged V8, competition gearbox, wheelie bar, roll cage... all you could want, in short, in a turn-key drag racer. And all that for a good cause.

2017 Ford F-150 Raptor desert testing heats up

In case there was any doubt, Ford is taking the development of the second-generation SVT Raptor very, very seriously. The Blue Oval recently completed over 1,000 miles of testing in the boiling heat of the American southwest. Apparently, that mileage was accrued over a 66-mile route designed to mimic the torturous terrain encountered by racers in the Baja 1,000 off-road race. The prototypes, which were built from a mix of existing and next-gen Raptor components, were tested with "fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches." Ford claims the new truck managed to run the circuit 25-percent faster than the current F-150 SVT Raptor, averaging 50 miles per hour while going as fast as 100 mph in stretches. That said, Dearborn didn't release any dedicated times, so it's unclear just how quickly the 66-mile stage was completed. We do know that durability was a big part of the testing. Ford claims each lap was completed by what sounds like a pretty significant jump, with the trucks ascending a steep ramp onto a two-foot plateau and then completing a step-down to level ground. We have to take Ford at its word here, though. "Steep" can mean any number of things, and we've no idea just how fast the trucks were hitting the ramp or how much air they got. Hopefully, the jumps were aggressive enough to prevent future frame issues. Still, Ford boasting about how rough the Raptor's testing is can be taken as a positive sign for fans of the next-generation of SVT's rugged pickup. NEW F-150 RAPTOR WRAPS UP INITIAL DESERT DURABILITY TESTING DEARBORN, Mich., July 7, 2015 – The 2017 F-150 Raptor – Ford's toughest, smartest, most capable off-road truck ever – recently completed more than 1,000 miles of testing in the southwestern United States. Over 1,028 miles of desert trail designed to parallel the Baja race course in Mexico, the 66-mile route featured a wide range of surfaces including fast sandy washes, deep-rutted silt beds, steep climbs in deep sand, and slow meticulous crawls through tight trenches. The truck topped speeds of 100 mph in places, slowing to 10 mph in others, for an average speed of approximately 50 mph. The 2017 Raptor is 25 percent faster than the current truck based on lap times. At the end of each lap, the new Raptor completed a tabletop jump consisting of a steep ramp up to a two-foot plateau, then a step-off back to level ground.

GM, Ford, FCA and the UAW form joint coronavirus task force

General Motors, Ford and Fiat Chrysler are forming a coronavirus task force along with the United Auto Workers union to improve protections for their employees and limit the spread of the highly contagious virus. The task force, which would be focusing on areas including vehicle production plans, is being headed by UAW President Rory Gamble, GM Chief Executive Officer Mary Barra, Ford CEO Jim Hackett, Ford Executive Chairman Bill Ford and FCA CEO Michael Manley, the parties said in a joint statement on Sunday. Though automakers typically schedule plant staffing to allow for a certain proportion of absent workers, according to industry consultants, if the outbreak causes higher levels due to infection or workers staying home to care for children whose schools are closed, that could lead to reduced production or in extreme cases shutdowns. Production at an FCA assembly plant in Canada was halted for 24 hours after employees there refused to work on Thursday over fears of an employee being possibly exposed to the coronavirus. Separately on Thursday, the Italian-American automaker said that one of its employees had tested positive for COVID-19, a respiratory disease caused by the new coronavirus, at its transmission plant in Indiana. The plant, however, remained open. "This is a fluid and unprecedented situation, and the task force will move quickly to build on the wide-ranging preventive measures we have put in place," the CEOs of the three companies said in the statement. The task force would also be focusing on aspects such as health and safety education, health screening, food service at the automakers' locations. Related Video: Government/Legal Plants/Manufacturing UAW/Unions Chrysler Fiat Ford GM coronavirus