Srt Viper Gts**brand New-brand New**manual/adrenaline Red/track Package on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2015 Dodge Challenger SRT Hellcat [w/videos]

Darrell Waltrip once said, "If the lion didn't bite the tamer every once in a while, it wouldn't be exciting." The sentiment behind that aphorism is causing my adrenal gland to wake up as Dodge and SRT drivers and engineers - somber-faced to a man - give me the track talk that will precede my driving the 2015 Dodge Challenger SRT on the circuit at Portland International Raceway. PIR might not be Daytona, and the 707-horsepower Challenger Hellcat might seem tame to a legend like ol' Jaws, but there's a not-small part of me that's thinking about how hard Dodge's fire-breathing kitty might bite.
Just a few hours previous, I'd gotten behind the wheel of the Hellcat for the first time, letting its hyperbole-spitting, supercharged V8 Hemi pull me yieldingly through Portland's morning commuter traffic. Lulled into a cocky certainty by the Challenger's good manners at low speed, I drove the throttle just a hair too deep, too fast when I ran on to the highway ramp. For just an instant the rear tires were utterly drenched in torque, and the back end of the big Dodge loosened up like a drift car on a wet track. Throttle steer lives at the fleeting whim of your right foot in this car.
It was no big thing to lay off the gas and pull the Hellcat back in line as I entered the highway, but the incident did get me to thinking: What will this car do to me on a road course?

Widebody Challenger Hellcat spotted with no camouflage

Well this is a mightily mysterious muscle car. One of our photographers caught this Dodge Challenger out testing without any camouflage. At first glance it looks like an SRT Demon, since it has the same widebody flares and front spoiler of the hellacious Challenger. However, the hood is from a garden-variety Hellcat (as if such a thing existed...), the rear spoiler has an SRT Hellcat badge, and the wheels don't come from the kitty or the Hellspawn. We have two theories as to what this SRT mishmash may be. Our first is that this is perhaps a next-generation Hellcat that takes advantage of some of the Demon's developments. It could have a more potent engine under the hood, perhaps with the extra fuel pumps and air-conditioned intercooler, along with the Demon's beefier driveline. It would be a way to keep the Hellcat relevant, and a way for people who might miss out on the one-year-only Demon to get the next closest thing. Our other theory is that this is an all-wheel-drive Hellcat. The wide fender flares and chin spoiler appeared on an all-wheel-drive Challenger concept before they made their way to the Demon. And with the introduction of the Grand Cherokee Trackhawk, we know that Mopar has an all-wheel-drive system that can handle the grunt of the 707-horsepower Hellcat mill. If an all-wheel-drive Hellcat is in the cards, it would be another way to keep the Hellcat line fresh without too much investment, and would be a treat for fans of the old all-wheel-drive concept. It would also probably be a great seller here in snowy Michigan. Oh, and it would certainly post some amazing 0-30 acceleration times. Related Video: