2013 Srt Viper on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

The last time Dodge recycled the Demon name, it was for a Miata fighter

We and the rest of the automotive world are eagerly awaiting the reveal of the Dodge Challenger Demon. And why wouldn't we be? It's going to be a Hellcat, but with less weight, bigger fenders, more performance, and more Vin Diesel. This isn't the first time we've been excited about a Demon from Dodge, though. Ten years ago, Dodge had another demonic car, but it was very different from the new one. The Demon of 2007 was a lithe little roadster that looked primed and ready to take on the Miata, as well as the now-departed Solstice and Sky twins. The Demon was just under an inch shorter than the MX-5 and the Solstice, and it packed a 172 horsepower 2.4-liter four-cylinder that fell right between the Miata's 170 and the Solstice's 177 outputs. Dodge's estimated the curb weight, which for a concept is largely theoretical, also slotted between the two cars at 2600 pounds. That was about 150 more than the Mazda, and about 200 less than the Pontiac. The pitch perfect specifications were presented in a crisp two-seat roadster wrapper. In many ways, it looked like a baby Viper, with a menacing crosshair grille, slanted headlights, and fat rear fenders. The Demon's line's were brutally simple and geometric, too. They didn't seem far removed from the first-generation Audi TT. The interior was also plain and simple. The key highlights were a horizontal aluminum accent that ran the width of the dash, echoed by an aluminum-covered center console. The instrument cluster was uncluttered, with just four gauges, and the only controls were some climate knobs, a double-DIN head unit, and a six-speed manual. It turns out that the 2007 Demon didn't drive very well, though. You see, we actually drove this concept back in the day, and like many concepts, it still had a long way to go to be production ready. The gearbox would grind, the ride quality was terrible. However, the interior was roomy, and the engine sounded suitably grumbly, if a bit coarse. At the time, we said Dodge should absolutely build the little roadster. In retrospect, the company probably made the right decision not to invest in the Demon. The small rear drive sports car segment was, and still is, an extremely niche market. It would have been a big investment for little return, something FCA today is trying to avoid. This is all before taking into account the fact that the recession was just around the corner. In the end, we can't be too sad though.

Dodge brings Charger Widebody 'concept' to Spring Fest

Last week we asked if an Instagram user had really seen a Dodge Charger Widebody cruising suburban Detroit. The answer is yes, he had. Dodge brought its Charger Widebody concept to Spring Fest 14, a celebration of everything built on Chrysler's LX platform. Note the use of the word "concept," and a Fiat Chrysler spokesperson telling journos, "We are taking a Charger design concept to Spring Fest to gauge feedback from the huge Dodge Charger, Challenger, and Chrysler 300 enthusiast base that attends the California event each year." Mark Trostle, head of design for Dodge and SRT, shared a few snaps of the Charger Widebody to Instagram. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Now ignore the word "concept." Of course a thing isn't done until it's done, but two years ago a thread on Charger Forums mused on a Photoshop of the sedan as a widebody. User ResumeSpeed chimed in to say, "Rear is not accurate as it's being revised. 2020 model year. Two Charger WB models: Hellcat and 392 Scat Pack." Fast forward to February of this year when Mopar Insider said its sources confirmed a thick-hipped Charger R/T Scat Pack and Hellcat with "drastically different looking front and rear fascias." Then, earlier this month, Allpar received a slide from what looks like an internal Dodge presentation explaining the "2020 Dodge Charger Hellcat Wide Body." The sedan in the slide looks almost exactly like the "concept." And now this. They even designed it with the Dodge Durango SRT grille treatment, which seems like a logical part of that 2020 revision. Giving the Charger a nip and tuck, a little more tire, and a $6,000 surcharge similar to the Challenger Widebody makes too much sense to merely toy with and then file away. Check out this video for a complete walkaround, and stay tuned.