2006 Dodge Sprinter Passenger Van Mercedes Diesel on 2040-cars

Auto blog

2016 Jeep Wrangler recalled over impact sensor wiring

Fiat Chrysler just announced a pair of recalls totaling nearly 311,000 units. The bigger recall affects certain 2016 and 2017 model year Jeep Wranglers. Although, since FCA claims all of the affected 2017s are in the company's hands, really, only 2016 owners should pay attention here. The affected Wranglers suffer from an issue where wiring disconnects from impact sensors in certain types of crashes, potentially preventing the airbags and pretensioners from activating. FCA uncovered the problem in what its press release calls "a routine, in-house crash test" and claims "service availability is imminent." The affected Jeeps require a simple rewiring. The other recall, announced Tuesday, is more of a fleet issue, affecting 2007 to 2013 model-year Ram 2500 and 3500 pickups and 3500, 4500, and 5500 chassis cabs and 2011 to 2014 Dodge Charger Pursuit police vehicles. There's a problem with "premature diode wear" in alternators that are subject to "frequent load cycling, at or near maximum amperage, [or] in hot ambient temperatures." Affected alternators could short out, causing a vehicle to stall or potentially catch fire. FCA lists 182,743 affected Wranglers in the US, 18,011 in Canada, 3,087 in Mexico, and 20,948 in global markets. The Ram/ Charger Pursuit recall lists 74,833 vehicles in the US, 10,077 in Canada, 1,088 in Mexico, and 134 outside the NAFTA region. Of all those vehicles, the Jeep recall hasn't caused any injuries or fatalities, while FCA says it's aware of one "potentially related injury" and no accidents due to its fleet vehicle recall. FCA says it will notify owners/operators of affected vehicles when service appointments are available. As per usual, all the work is free of charge. Related Video:

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Dodge Vipers selling for $480k in China

Want to get your hands on a new Dodge Viper? Be prepared to pay dearly. It starts at nearly $90k here in the US, but that's nothing compared to what you'd have to pay for one if you lived in, say, China. CarsNewsChina.com reports on one Viper available in Beijing for an eye-watering 298 million yuan – equivalent to about $480,000 at today's exchange rates and representing more than a 500-percent markup. Part of that premium comes down to the Chinese tax code that charges a reported 60 percent for anything with an engine displacing over four liters. And the Viper's, we needn't remind you, is more than twice that. It naturally costs some to import a car to China as well, but most of the rest is pure profit. The Beijing dealership reportedly gets the cars from dealers in California, has already sold three and plans to import several more. The dealer can also get you (or wealthy Chinese individuals) a Corvette Stingray for a comparatively cheap 1.73 million yuan (or $280k). Related Video: