Dodge Dually 6.7 4x4 Custom 5th Wheel Bed on 2040-cars

Auto blog

Dodge Challenger ADR Spied | Autoblog Minute

Dodge Autoblog Minute Videos Original Video autos challenger

Dodge Charger to slim down and run turbo four in next generation

The current Dodge Charger is getting long in the tooth. It was originally introduced in 2005 as a 2006 model. In car terms, that's an eternity, though it's been refreshed twice. Still, FCA US will keep the LX-generation car going, reportedly facelifting it one last time for 2019. After that, there are some bigger changes in store . Automotive News is reporting that the follower to the current LX Charger will lose almost 500 pounds and will once again offer a turbo four-cylinder. You might remember the front-wheel-drive four-banger Charger of the early '80s. The recharged sedan will be twin-turbo and it's going to use the 300-horsepower four-cylinder engine currently under development for the 2018 Jeep Wrangler, AN says. The target weight for the future car is around 3,500 lbs, while the current car has a curb weight of nearly 4,000 lbs. Look for it to arrive in the early 2020s. The new platform will have a touch of Italian flair instead of the Daimler-Benz flavor embedded deep inside the LX cars. It will be built on an extended version of the 2017 Alfa Romeo Giulia's "Giorgio" platform, according to AN. Dealers were already shown a styling-buck almost a year ago. Related News: Featured Gallery 2015 Dodge Charger R/T View 42 Photos News Source: Automotive NewsImage Credit: AOL Alfa Romeo Dodge Future Vehicles Sedan FCA

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.