5.9 Cummins Stick Shift Manual 6 Speed Six Speed 4x4 4wd Diesel Cummings on 2040-cars

Auto blog

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Dodge Charger SRT Hellcat in the works

In Autoblog's recent First Drive of the 2015 Challenger SRT with the 707-horsepower Hellcat V8 we found its engine to be as brutally powerful as the numbers would suggest, even if it wasn't the best handler. However, the muscle-car-styling just isn't right for some buyers that need four doors and proper rear seats to haul around the family. It appears that Dodge has their backs, though, because the Hellcat is very likely on its way into the Charger in the near future. Imagine the looks on your passengers' faces when you stomp down on the throttle.
According to Road and Track, when Dodge submitted the Hellcat for engine power certification to the Society of Automotive Engineers, the company included the Charger on the paperwork. That showed that the automaker wanted the engine checked out for the sedan, too. R&T reckons the 707-hp Charger would hit the road about a year from now, clearing the Challenger for a year of exclusivity with the powerplant.
When the Charger SRT Hellcat does hit the road, it may carry a very special accolade. Assuming nothing beats it in the meantime, it might be the world's highest horsepower production sedan. Think on that for a second. Even a Mercedes S65 AMG only has 621 horsepower, though a good bit more torque at 738 pound-feet to the Dodge's 650 lb-ft. So while the beastly engine is getting put into other models, where else would you like to see it? The Ram? Grand Cherokee? Let us know in Comments.

Fiat Chrysler dumped 40,000 unordered vehicles on dealers

In a move that echoes recent history, Fiat Chrysler has been making more cars and trucks than dealers in the U.S. are willing to accept, with Bloomberg reporting that at one point the automaker had built up a glut of around 40,000 unordered vehicles. That’s led some dealers to accuse FCA of reviving the dreaded “sales bank” accounting practice of obscuring inventory to improve the balance sheet. The company reportedly began building up its inventory of unordered cars this summer despite an industrywide slowdown in sales and an eagerness by some dealers to thin their inventories because rising interest rates are making it more expensive to hold unsold cars. The inventory build-up also coincided with Fiat ChryslerÂ’s efforts to find a merger partner, first with Renault, which fell through, then last monthÂ’s announcement that it will merge with FranceÂ’s PSA Group. FCA denies any such scheme and tells Bloomberg the rising inventory is down to a new predictive analytics system designed to better square supply with demand from dealers that is helping the company save money and narrow the numbers of unsold vehicles. The company recently agreed to pay a $40 million civil penalty to the U.S. Securities and Exchange Commission to settle a complaint that it paid dealers to report fake sales figures over a span of five years. While no one is suggesting that FCA is in dire financial straits — the company saw higher than expected earnings in the third quarter and record profits in North America — the practice has strong historical precedent by Chrysler, which built up bloated inventories in the run-up to its two federal bailouts, in 1980 and 2009. It was also common at GM and Ford during the 2000s, when all three Detroit automakers struggled with excess manufacturing capacity and plummeting sales in the lead-up to the Great Recession. Back in 2012, CFO Magazine wrote about a report that explained automakersÂ’ rationale for the practice and how it works: Say fixed costs for a given factory are $100, and that the factory can make 50 cars. Consumers, however, demand only 10. Under absorption costing, if the company makes all 50 cars, its cost-per-car is $2. If it makes only up to demand, or 10 cars, the cost-per-car is $10. Although each car adds variable costs for steel and other parts, if those costs are low, the company still has an incentive to make more cars to keep the cost-per-car down.