2009 Ram 2500 4x4 Quad Cab Slt 5.7l Hemi V8 Auto Short Bed Tow Package 66k Miles on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Thieves still love older Hondas and pickups most, says NICB [w/video]

No one wants to have their car stolen, but a new study by the National Insurance Crime Bureau has some bad news for older Honda owners and pickup drivers. Fortunately, it has better news for drivers overall. The group is reporting that according to preliminary data from the Federal Bureau of Investigation, thefts were down 3.2 percent in 2013 (versus 2012) to fewer than 700,000 cars. That's the lowest figure since 1967. That's also less than half of the peak of over 1.66 million thefts in 1991. "The drop in thefts is good news for all of us," says NICB President and CEO Joe Wehrle. "But it still amounts to a vehicle being stolen every 45 seconds and losses of over $4 billion a year."
Honda drivers might not find it such good news with older Accord and Civic models topping this year's theft study. Toyota and Dodge can't really celebrate, either, with two models each on the list, as well. Overall, this year's list was split evenly between foreign and domestic models, which were mostly pickups.
The 10 most likely vehicles to be stolen in 2013 were:

That thing got a Hemi? Mopar engine kits make it easier to say yes

Thanks to a new kit from Mopar, classic car owners will have an easier time dropping Hemis into their muscle cars. The kit works with Mopar's 345 and 392 Hemi engines (5.7 and 6.4 liters respectively) and with cars built before 1975. The kit will run $1,795 and has everything needed to get one of the above engines running. The parts include a power distribution system, engine computer, engine and chassis wiring harnesses, O2 and intake air temperature sensors, ground wiring and a gas pedal. The kit is also designed to work with a manual transmission, but Mopar says a transmission such as the Torqueflite 727 and 904 can be made to work with the system. As for examples of the kit in action, take a look at the Jeep CJ66 and Dodge Challenger Shakedown that Mopar revealed this week at the SEMA show. Mopar also offers a few other parts to help complete the project, including various oil pans to clear subframes, a set of headers, and accessory drives for power steering and air conditioning. All of these parts are extra cost though. You'll also need an engine, and the 345 starts at $6,070, and the 392 runs $9,335. However, if you happen to already have one from 2014 or newer, that will work, too. Muscle car fans are getting more choices for their engine conversions. Chevrolet Performance already sells crate engines with "Connect and Cruise" kits to get its engines working in classic cars. The General also offers it with more engines. However, for people who want to keep a Mopar engine in their classic Chrysler, Dodge, Plymouth, or Jeep, this is a cool new option. Related Video: Featured Gallery Mopar Hemi V8 Engine Swap Kit Image Credit: FCA Aftermarket SEMA Show Chrysler Dodge Performance Classics FCA engine swap SEMA 2016