2006 Dodge Ram 2500 St Crew Cab Pickup 4-door 5.9l on 2040-cars

Auto blog

A look at the Dodge Demon's drag settings, modes, and go-fast tech

In the same video that gave us a peek at the 2018 Dodge Challenger SRT Demon's performance stats, there's a serious dump of info on the tech and tools that will likely help this muscle coupe slaughter drag strips. Dodge has outlined a few of them for us and we're using the power of inference to figure out the rest. Here's what we've gathered. A lot of these hints come from the Demon's version of Performance Pages, the infotainment screens that show what SRT models are doing and let the driver change the powertrain and chassis setup. There are a lot of Demon-only features, including line lock, a quick cooldown mode for the supercharged engine, and data recording. And of course there are pages to show a digital time slip with acceleration and braking figures, a g-load plot, and lots of gauges to track temps and levels. The engine output is shown in the video on a special Dyno page. It tracks horsepower and torque over time on the upper graph, and engine rpm and shift points on the lower graph. And we think it's still hiding something. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Any good drag car has a line lock, allowing the driver to lock the front brakes and leave the rears free to do a nice tire-warming (or tire-shredding, depending on length) burnout. Ford has it on the Mustang, Chevy puts it on the ZL1, and now Dodge is adding it to the Demon. It should help get the giant Nitto tires up to temp for a drag run. And once the tires are warm, there's launch control, just like on the SRT Hellcat, with selectable rpm to dial things in for the conditions. The Demon also has a shift light in the cluster, and the driver can set a shift point individually for each gear. After each drag run, you can activate Quick Cooldown, which Dodge says uses the first production application of After-Run Chiller – it runs the cooling fan and intercooler coolant pump with the engine off until the coolant reaches its target temp. It's shown in one of the slides above. The checklist on the left side of that page suggests it requires a set of conditions be met to work: engine off, hood open, and sufficient battery level. This further reinforces our theory that the supercharger is going to make big boost, beyond the Hellcat's 11.6 psi. And while you're waiting for the supercharger to cool off for another run, you can review the performance data the car records.

VLF Force 1 V10 is a rebodied Viper priced like a Lamborghini

It would appear that Henrik Fisker is done with hybrids. His latest project, called the Force 1, packs an oversized V10 engine with no electric assist in sight and all the environmental credentials of a herd of flatulent cattle. Alongside the Karma-based, Corvette-powered Destino, the Force 1 is the second product from VLF Automotive. Fisker has taken partnership in the new firm as chief designer alongside chairman Bob Lutz and CEO Gilbert Villarreal. The company isn't saying explicitly what the Force 1 is based on, but it doesn't take a CSI team to trace its roots back to the Dodge Viper. Never mind that it's being built in Auburn Hills – the same Detroit suburb where Chrysler is headquartered – or that it was jointly developed by Fisker and professional Viper racer and dealer Ben Keating. It also happens to be powered by an 8.4-liter V10, and there aren't many of those kicking around the industry. Instead of the Viper's 645 horsepower and 600 pound-feet of torque, the Force 1's ten-cylinder engine is optimized to deliver 745 hp and 638 lb-ft. That, according to VLF, is enough to send the coupe rocketing to 60 in 3.0 seconds flat, covering the quarter-mile in under 11 seconds on its way to a top speed of 218 miles per hour. The power is transmitted to the Pirelli PZero rubber through a six-speed manual, but VLF says it will fit it with an automatic at the customer's request. Around that massive engine and two-seat cockpit, Fisker designed a new shape that, for better or for worse, looks way more aggressive than the Viper's. The Force 1's proportions are tellingly super-snake, but the curves are replaced by some very angry-looking angles and vents. Its head- and taillights are ultra thin, and the deep-dish, split-four-spoke wheels seem to visually split the difference between the three-spoke wheels on the original Viper and the five-spoke alloys it wears today. If you doubted the Force 1's origins before, the interior ought to give it away, with its wide tunnel and familiar surfaces. Only VLF has refinished it in leather, suede, and Alcantara, all diamond stitched with contrasting thread to help position this as a more luxurious prospect than the Dodge. It even fit between the seatbacks place for two champagne bottles that we hope nobody would consider consuming before trying to handle that much power. Of course, none of this will come cheap.

Tempted by the Demon, dealers find way to thwart Dodge, jack up prices

It's the eternal story of short supply, big demand - and car dealers eager to exploit that dynamic, especially when it involves a hot car. A few weeks ago, when Dodge announced that it devised a way to attempt to prevent price-gouging on those 840-horsepower 2018 Dodge Demons, you just knew the dealers would dream up some devilish end-run. And sure enough, despite the manufacturer's best intentions, Demon order slots are being offered with five-figure markups. Here's how things were supposed to work: With a run of just 3,000 cars, Dodge knew it had to do something to address dealer greed, so it announced an allocation system: Cars purchased at or below the $86,090 MSRP would be the first orders filled and delivered. If a dealer sells an allocated Demon for more than sticker, that car goes to the end of the line for production and delivery. Dodge also ensured dealers wouldn't stockpile or hoard Demons by limiting the number of orders a dealer can submit and allocating cars to dealers based on how many Challenger and Charger Hellcats the dealer has sold. But Automotive News reports that some dealers are using intermediaries to auction off their Demon allocations on eBay. Three sellers last week said they were representing dealers in South Carolina, Tennessee and Louisiana, and auctioning off the right to buy a car in one of the priority spots at MSRP. The minimum bid for the right to buy the car at sticker? From $10,000-25,000. And previous transactions on eBay might have run as high as $75,000. So early buyers are definitely paying an upcharge - but it's a thing apart from the bottom line on the order form, where it appears they are paying MSRP. In other words, a scheme that violates the spirit of what FCA tried to do. A source at FCA told Automotive News the automaker was monitoring the practice but could do little to stop it. And the report quoted a Hellcat owner who said his dealership was ignoring Dodge's strictures altogether and offered him a Demon at MSRP plus $60K. But take heart. Not all car dealers are cynically opportunistic - or rather, some see an opportunity for doing good, not making buck. Automotive News says Bill Marsh Chrysler in Traverse City, Mich., plans to sell its single allocated Demon for $1 under MSRP - and is auctioning off the right to buy it, with the dealership's existing customers eligible to bid. The auction's proceeds will benefit four Traverse City charities.