2005 Dodge Ram 2500 Laramie Crew Cab Pickup 4-door 5.9l on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Viper production to end after 2017

We can't say we're surprised, but we're still saddened to report that the Dodge Viper will not live on past the 2017 model year. It's had a solid 25-year run, though, and that's worth celebrating. Fiat Chrysler Automobiles does just that for the Viper's final model year, with five special editions (some of which seem less special than others, admittedly): The 1:28 Edition ACR, GTS-R Commemorative Edition ACR, VoooDoo II Edition ACR, Snakeskin Edition GTC, and Dodge Dealer Edition ACR. Instead of running through what makes each of these 2017 Vipers special, we'll direct your attention to the press release below and the images above. All but the Dodge Dealer Edition commemorate memorable Viper models of the past 25 years, and the GTS-R is probably the pick of the litter with its classic blue-on-white paint scheme. Unless you prefer to err on the side of gaudy, in which case Dodge has you (and your car) covered with Snakeskin Green. If none of these special-edition Viper models strikes your fancy but you'd still like to park a 2017 Viper in your garage, fret not. Dodge is still offering its "1 of 1" customization program for the Viper's final year of production. Finally, instead of dwelling on the past, even when that past is as exciting as the Viper's, let's choose to look to the future with the only logical question left unanswered: What's next? Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.