1999 Dodge Ram 2500 Base Extended Cab Pickup 4-door 5.9l on 2040-cars

Auto blog

Indications of 825 hp and emissions issues for Hellcat called 'speculation' by Chrysler

The 2015 Dodge Challenger SRT Hellcat is probably one of the hottest cars of the moment mostly because of its insane, 707-horsepower supercharged V8. However, there are conflicting reports coming out that the powerplant might be having problems with its emissions compliance and may be capable of even more power.
Jalopnik says that an unnamed source within Fiat Chrysler Automobiles told it that the Hellcat was having problems meeting emissions standards at its 707-horsepower tune. The person claimed that the automaker has been testing the V8 with different types of sensors, possibly to make it a bit cleaner in the future. Autoblog spoke to SRT spokesperson Dan Reid, and he said about the claimed poor emissions, "It's totally speculation."
The source also claimed that the Hellcat had been dynoed at a monumental 825 horsepower, internally. Based on the other rumor, though, it's hard to imagine the engine being emissions compliant like that. Autoblog also asked Reid about this speculation about more power and was told, "They are totally speculating about that."

Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission

What do the Chrysler 300, Dodge Charger and Ram 1500 all have in common? Yes, they're all Chrysler products, and two of them are based on the same platform. And we're sure you could find more similarities between them all, but the common trait we're looking at here is that, while they all come standard in rear-drive form, they're also available with all-wheel drive. And it's the transmission in those models that's the subject of the latest recall notice issued by the National Highway Traffic Safety Administration.
The output shaft on the eight-speed automatic transmission supplied by ZF to Chrysler for the AWD versions of the 300, Charger and Ram 1500 is apparently prone to fracture. That in the end could leave the vehicle without power and could, according to the NHTSA investigation, increase the chance of a crash. The vehicle could also roll away if even if left in Park without the handbrake applied.
That's why Chrysler is calling in 4,194 examples of those three models from the 2013 model year. Dealers will be responsible for inspecting the transmissions and, where necessary, replace the entire unit. See the full recall notice below for all the details.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.