2005 Dodge Ram Srt-10 Quad Cab Only 45k Miles! V10 Moonroof Navi Upgrades! Wow$$ on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Armormax loads a bulletproof Dodge Hellcat AWD Police Special

Earlier, we wrote about the Armormax armored Tesla Model S P100D, which International Armoring Corporation called the fastest armored car in the world. As the company also outfits cars such as Dodge Chargers, it's only logical that the showcase car is a SRT Hellcat — but the interesting thing is that the company can also upgrade the Hellcat to all-wheel drive, as Armormax told Motor Authority. When ordering an armored Charger SRT Hellcat, the AWD implementation is just a matter of ticking the corresponding box. The Armormax Charger SRT Hellcat seen here is also outfitted with police patrol car gear, complete with a push bar, run-flat tires, ballistic bulletproof glass and a mean matte black wrap. Even if the 6.2-liter, supercharged Hellcat powertrain probably has no problem hauling an armored bodyshell around, it's likely that the company has used the same synthetic fiber laminate on the Charger as on the Tesla. The bulletproof Tesla's weight gain was a negligible 11 percent, and while the Charger is a lighter car to begin with, avoiding using regular-issue ballistic steel seems to be the way to go if you want to keep the curb weight in check. The Hellcat's battery, radiator, fuel tank and ECU also get their share of protective covering, so that the vehicle is harder to disable. Paneling is available in ballistic protection levels ranging from B4 (can withstand a .30-caliber lead-core softpoint bullet) to B7 (can withstand a 9mm full-copper jacket). And while pricing isn't announced, it is likely to depend on how much protection is applied on the Hellcat and whether all four wheels are powered. A stock one is priced at $65,345. Related Video:

Make Your Dodge Durango Even Better | MoPar Options for R/T, SRT | 2018 Chicago Auto Show

Fiat Chrysler is showing new performance add-ons for the 2018 Dodge Durango R/T and SRT models at the Chicago Auto Show, including the familiar Dodge dual center stripes and a new Mopar exhaust system. The 475-horsepower SRT model, which is powered by a 6.4-liter Hemi V8, will also offer a lowering spring kit and a carbon-fiber instrument panel. Chicago Auto Show Dodge Autoblog Minute Videos Original Video SRT