2002 Dodge Ram 1500 on 2040-cars

Auto blog

Cars.com runs 11-second quarter with Dodge Charger Hellcat

The Dodge Charger SRT Hellcat and its Challenger sibling are two of the heroes of the modern performance world. With a headline-grabbing 707 horsepower from a supercharged 6.2-liter V8, their output even shames many supercars. But how quick can one really cover a quarter mile? Cars.com recently decided to find out by taking a Charger Hellcat to the drag strip to see if the sedan lived up to Dodge's 11-second claims. The results were quite impressive. After 13 quarter-mile runs of adjusting variables like the tire pressures and the car's various electronic aids, the Charger Hellcat managed a pass in 11.03 seconds at 126.61 mph – the pinnacle result of the day. This car was mechanically stock and wore the optional Pirelli P Zero tires. According to Cars.com, other quick sprints reached 11.09 seconds and 11.1 seconds, which even beat the site's 11.41-second best from a Challenger Hellcat last year. Getting the Hellcat's prodigious power down without losing traction was a challenge, even on the summer tires. Cars.com thought it had a run that could have dropped below 11 seconds, but then the wheels spun. Using the factory-recommended pressures, the Charger Hellcat was no still slouch with an 11.27-second time recorded, but taking things down to 25 psi proved the quickest at the strip. We already knew that the Charger Hellcat was a wonderful vehicle for eating up huge gulps of asphalt at high speeds and could verify its 204-mile-per-hour top speed (quite a bit faster, incidentally, than the Ferrari California T's 196 mph top-speed). Apparently, the 11-second quarter-mile claim is just as accurate. Also, for any curious owners, the Cars.com story divulges many of the tweaks required to reach this seriously quick time. Related Video:

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Hero gets his truck back better than new thanks to community support [w/video]

You ever hear a story and start cringing before you hear the end because you know how it's going to turn out? That could very well have been the case with the story from a few weeks ago in West Valley City, Utah, where a 14-year-old kid stole his grandfather's Hyundai Veloster and took it for a joyride - through a park full of children. But instead it turned into a heart-warming tale of heroism and a community banding together to do what's right... and then some.
Bryson Rowley was that hero who identified the danger and, rather than sit idly by and watch the joyrider potentially run over a child, got into his truck and drove it into the menacing runaway hatchback. The collision caused some $7,500 to his 2008 Dodge Ram 2500, but instead of getting stuck with the bill - one which his insurance may very well have refused to pay since the crash was, technically speaking, intentional - his community pitched in a helping hand.
Bryan Ellison, who owns West Valley Carstar with his brother, saw the news on television and wanted to help. So he brought Rowley a rental car, picked up his truck and brought it back to his auto repair shop. People from around the community donated parts, and when all was said and done, some $15,000 of work and upgrades were performed on the Ram that was returned to an overwhelmed Bryson Rowley better than new. Watch the video below for the full story.