2008 Dodge Magnum Base on 2040-cars

Auto blog

Dodge Charger Hellcat makes 1,032 hp with Hennessey help

Sometimes you just want four doors. Earlier this week we brought you Hennessey's riff on the Dodge Challenger Hellcat. Now comes the Charger. Much like its two-door sibling, the Charger gets boosted to as much as 1,032 hp and 987 lb-ft of torque (at the crank) thanks to the addition of a twin-turbocharging setup that works with the factory supercharger. The turbo headers and downpipes are stainless steel, and there is a high-flow air-to-water intercooler and dual-turbo waste gates. Hennessey also beefs up the fuel injectors, fuel pump, and the rest of the fuel system. The engine management system and chassis are recalibrated to accommodate all of this. You also get numbered plaques signed by John Hennessey, the boss of the Texas tuning outfit, and the technician who does your build. Hennessey's additions result in zero-to-60 mph sprints in 2.7 seconds, and the big sedan can run the quarter mile in 9.9 seconds at 142 mph. Like the Challenger, the Charger has the same disclaimer: the lofty horsepower figure comes from an engine dyno, and it will be a 15-to 20-percent lower at the rear wheels. Related Video: Image Credit: Hennessey Performance Dodge Performance Sedan Hennessey dodge charger hellcat

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

Fort Worth Police investigating officer for using pepper spray on bikers

A Fort Worth Police officer was placed on administrative duties after video surfaced showing him allegedly spraying pepper spray at a group of passing motorcyclists during a traffic stop over the weekend. An officer with the FWPD pulled over one of the group's chase vehicles, a red Dodge Ram, that was escorting riders in case of a crash or mechanical troubles. The video, shot from one of the motorcyclists' helmet cams, caught the FWPD officer exiting his vehicle and, before approaching the truck, spraying something into traffic at the group of riders. WFAA News 8 spoke with the men responsible for the video, Jack Kinney and Chase Stone, via Skype from Longview, TX, on March 13. "It's the last thing I would expect to see," Kinney told the station. "His intent was to hit the bikers for sure, there's no doubt about it," said Stone. "His intent was to send somebody down, if not to cause a major accident with that spray". As the video went viral, receiving more than 200,000 views in 15 hours, people shared videos showing the group of motorcyclists riding in an irresponsible manner through traffic right before the alleged pepper spray incident. Fort Worth Police say they received numerous calls about the pack of riders from motorists on surrounding highways, with complaints ranging from weaving in and out of lanes to popping wheelies through traffic at high speed. News 8 asked Kinney and Stone if it was possible that the officer felt threatened. "If you're worried about safety, why would you pepper spray a large group of bikers like that?" asked Kinney. The Dallas Morning News identified the officer as W. Figueroa. Worth Police released an official statement about the incident late on the afternoon of March 13. They stated that the officer in question, a six-year FWPD veteran, had been relieved of his patrol duties and placed on desk duty pending the investigation. FWPD Corporal Tracey Knight also made a statement indicating that pepper-spraying drivers in oncoming traffic is not a department-sanctioned tactic. News Source: WFAA News 8, The Dallas Morning News Government/Legal Dodge RAM Safety Truck Motorcycle Police/Emergency Videos Sedan road rage bikers