2008 Dodge Magnum Base on 2040-cars

Auto blog

Chop the top of your new Dodge Viper for $35,000

We have good news, and we have bad news. First, the good: It's now possible to get a brand-new Dodge Viper roadster, which is nice, considering we're in the dead of summer and many of us like wind-in-the-hair motoring. Now, the bad: This is not a factory option from the automaker, instead coming courtesy of an aftermarket company called Prefix Performance, and that means it's going to cost you some serious coin.
Called Medusa, this drop-top Viper was created without the knowledge or consent of Dodge, but that's probably fine because Prefix works with the automaker already for the final preparation of the American supercar, including paint. According to the company, the current, fifth-gen Viper was built with a convertible version in mind, so no chassis strengthening is required. From the looks of the somewhat grainy photos available, the conversion appears of very high quality.
Want one? Well, that means you're going to need to procure a Viper - Prefix has 10 units ready for transformation as it stands - and that's going to cost at the very least $102,485. Then, you'll need to write a check for an additional $35,000 for Prefix to surgically remove the car's roof. Thing is, for that kind of cash, a prospective owner could buy, among other very nice options, a Viper hardtop and a loaded Miata, or a Corvette Stingray convertible and several pockets full of change. Or, perhaps a new Viper hardtop and a used, first-gen Viper convertible?

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

2020 Dodge Charger Hellcat Widebody, Scat Pack Widebody get grip, go faster

You all knew this was coming. Dodge basically showed it to the public a few months ago. But it's finally official, the 2020 Dodge Charger Hellcat Widebody and naturally aspirated Scat Pack Widebody are going into production. Like the Challenger Widebody, the Charger version is defined by its, well, wide body, which is now standard on all Hellcats and an option on Scat Packs. The fender flares add a total of 3.5 inches of width. Dodge also tweaked the front and rear bumpers and added wider side skirts to help the flares blend into the body. The Hellcat gets a unique rear spoiler, whereas the Scat Pack sticks with the same one its scrawnier twin uses. 2020 Dodge Charger Scat Pack Widebody View 20 Photos But the big advantage to this wide body is the fact Dodge can stick way more tire under the Charger. All Charger Widebody models get 11-inch-wide wheels with 305-mm tires at all four corners. Each version gets revised suspension, too. The Hellcat gets stiffer front springs, thicker front and rear anti-roll bars and retuned shocks. The Scat Pack gets a similar update, but without the thicker front anti-roll bars. Both cars also get six-piston front brake calipers from Brembo with two-piece rotors. All these handling upgrades mean the Charger is an even more impressive track machine. Dodge says the Hellcat now pulls 0.96g on a skid pad, and the Scat Pack Widebody does a little better at 0.98g. The Hellcat has also improved its lap time of Chrysler's 2.1-mile test course by 2.1 seconds, and the Scat Pack improved by 1.3 seconds. Both cars are also still fast in a straight line, with Dodge saying the Hellcat will hit 60 mph in 3.6 seconds on the way to a 10.96 quarter-mile time. Which, Dodge proclaims, makes it the world's most powerful and fastest mass-produced sedan. The Scat Pack Widebody will hit 60 in 4.3 seconds on the way to a 12.4-second quarter-mile.