Dodge Shelby Lancer on 2040-cars

Auto blog

MotorWeek remembers a better time for Mitsubishi performance

Dodge still knows how to create an capable performance car – look at the Hellcats, for example – but the same isn't true for Mitsubishi. With the Lancer Evo's demise, we don't expect driving enthusiasts to clamor for any of the Japanese automaker's other products. Things used to be different, though. As MotorWeek found in its new Retro Review, the 1991 Mitsubishi 3000GT VR4 and its sibling, the Dodge Stealth R/T Turbo, were impressive sports coupes in their day. Dodge and Mitsubishi packed a bevy of cutting-edge tech into the coupes. In these trims, both sported all-wheel drive, four-wheel steering, an adjustable suspension, active exhaust, and automatic climate control. The 3000GT VR4 upped the ante even more with active aero parts at the front and rear. Their 3.0-liter twin-turbo V6 was good for 300 horsepower and 307 pound-feet, which were good numbers at the time. This pair put all their gizmos to good use, too. MotorWeek compares the all-wheel-drive system's grip levels to a Porsche 911 Carrera 4. When was the last time you heard any favorable similarity between a Mitsubishi and a Porsche? The Stealth R/T Turbo and 3000GT VR4 came from a special time for Japanese sports coupes, when every brand had a halo model. Whether you were looking at Nissan 300ZX, Mazda RX-7, Toyota Supra, or even the Acura NSX, there was a lot to like on the market. MotorWeek's latest Retro Review offers a great reminder of that period.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

1970 Dodge Charger destroyed by man sick of lowballers — he showed them!

There are open and shut cases, and there's this one, the purchase and crush case. This is so wild it's hard to believe it's real. Apparently a man named Daniel Gagliardi bought a rusted-out 1970 Dodge Charger project car with the intent to flip it. Contacted by The Drive, Gagliardi said he bought the car for $4,200 and listed it for $8,500. "It was a complete car," he said, "not missing a single thing inside, out, underneath, under the hood, wasn't missing a damn thing. Had fender tag, VIN tag, clean title." Instead of negotiating with serious buyers, Gagliardi told the outlet a stream of jokers jerked him around for six months. The time-wasting took a toll, and after 180 days of "no-showers, thousands of no-showers, and a whole bunch of flakers" who didn't have the decency to bring a decent offer and cash, he decided to teach them all a lesson. So he destroyed the car, filmed the destruction, and cheered it on. The humorous and ironic part of the video is when Gagliardi tells another man off-camera, "But we got it first! We already robbed it, you can only rob it once!" After that levity, there's only chagrin for anyone sad to see a Charger meet its end so spitefully. Admittedly, however, and in spite of all the vitriol aimed at him, Gagliardi is free to destroy his own property. He's not the first person to crush a car capriciously. Any divorce attorney could tell you a book of tales about precious goods meeting ugly ends for vindictive reasons. Or there's the guy who, commenting on Gagliardi's video on another site, relates how he crushed the Yamaha quad he wanted $800 for after he "got tired of people offering me $200." Ah well. This won't be the last time. Warning for language, and exceptionally shaky video. If you're hungry for more Charger carnage after this, check out the cinematic obliterations in "7 Ways to Destroy a Charger."