Braun Enternvan Wheelchair Handicap Accessesible Van on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2.1 million vehicles recalled again over faulty airbags

Fiat Chrysler Automobiles, Honda and Toyota will recall 2.1 million vehicles to fix faulty airbag modules "after the manufacturers' original attempts to fix the defects proved ineffective in some vehicles." These vehicles had all previously been recalled, but the National Highway Traffic Safety Administration found that the airbags could still potentially malfunction. This recall will cover Acura MDX, Dodge Viper, Jeep Grand Cherokee, Honda Odyssey, Pontiac Vibe, Toyota Corolla, Toyota Matrix and Toyota Avalon models made in the early 2000s. NHTSA has reportedly received about 40 reports of airbag deployment in such vehicles, even though the vehicle had not been involved in a crash. Roughly one million of these same vehicles, all from Honda and Toyota, are also subject to recalls due to faulty Takata airbag modules, though this particular recall is for "an electronic component manufactured by TRW" that is separate from the actual airbags from Takata. According to NHTSA Administrator Mark Rosekind: "This is unfortunately a complicated issue for consumers, who may have to return to their dealer more than once. But this is an urgent safety issue, and all consumers with vehicles covered by the previous recalls should have that remedy installed. Even though it's a temporary solution until the new remedy is available, they and their families will be safer if they take the time to learn if their vehicle is covered and follow their manufacturers' instructions. A hassle is much better than a family tragedy." If you're the owner of an affected car, expect to hear more from the official automaker and government channels in short order. In the meantime, we'd suggest getting your car checked and fixed at your local dealer. The official statement and recall information can be found below. Previously Recalled Vehicle Remedies Not Working as Designed; NHTSA Announces Follow up Recall of 2.12 Million Cars and SUVs Saturday, January 31, 2015 Contact: Gordon Trowbridge, 202-366-9550, Public.Affairs@dot.gov WASHINGTON – U.S. Transportation Secretary Anthony Foxx announced today the recall of more than 2.12 million Acura, Dodge, Jeep, Honda, Pontiac, and Toyota vehicles for a defect that may cause airbags to deploy inadvertently. The recalls will provide vehicle owners with a new remedy after the manufacturers' original attempts to fix the defects proved ineffective in some vehicles.

2015 Dodge Viper getting small increase in power

The Viper is used to being the most powerful car in the Dodge and SRT stables, but the arrival of the 2015 Dodge Challenger SRT Hellcat means that's no longer the case. The serpentine supercar is, however, reportedly getting a small boost in output for 2015, amounting to all of five horsepower.
The increase was uncovered by Road & Track courtesy of the SAE J1349 certification process to which Detroit's Big Three automakers submit themselves and which reports the Viper's output at 645 hp instead of the 640 it was rated at until now. There are a hundred factors that could have contributed to the relatively mild boost in output (best guess? nothing at all changed...), but we doubt anyone's going to complain about some extra horses under the hood.
The five-horsepower boost brings the Viper that much closer to the 650-hp Chevy Corvette Z06, not to mention the 707-hp Hellcat, but the Viper's impressive power-to-weight ratio ought to mean it'll have little problem keeping up in a straight line - which is just one of the reasons why Chrysler won't shoe-horn the Hellcat into the Viper: as R&T points out, the supercharged engine is too heavy and the blower makes it too tall to fit in the Viper's engine bay.