2011 Dodge Durango Heat Suv **custom**head Turner! on 2040-cars

Auto blog

Ford, Stellantis workers join those at GM in ratifying contract that ended UAW strikes

DETROIT — The United Auto Workers union overwhelmingly ratified new contracts with Ford and Stellantis, that along with a similar deal with General Motors will raise pay across the industry, force automakers to absorb higher costs and help reshape the auto business as it shifts away from gasoline-fueled vehicles. Workers at Stellantis, the maker of Jeep, Dodge and Ram vehicles, voted 68.8% in favor of the deal. Their approval brought to a close a contentious labor dispute that included name-calling and a series of punishing strikes that imposed high costs on the companies and led to significant gains in pay and benefits for UAW workers. The deal at Stellantis passed by a roughly 10,000 vote margin, with ballot counts ending Saturday afternoon. Workers at Ford voted 69.3% in favor of the pact, which passed with nearly a 15,000-vote margin in balloting that ended early Saturday. Earlier this week, GM workers narrowly approved a similar contract. The agreements, which run through April 2028, will end contentious talks that began last summer and led to six-week-long strikes at all three automakers. Shawn Fain, the pugnacious new UAW leader, had branded the companies enemies of the UAW who were led by overpaid CEOs, declaring the days of union cooperation with the automakers were over. After summerlong negotiations failed to produce a deal, Fain kicked off strikes on Sept. 15 at one assembly plant at each company. The union later extended the strike to parts warehouses and other factories to try to intensify pressure on the automakers until tentative agreements were reached late in October. The new contract agreements were widely seen as a victory for the UAW. The companies agreed to dramatically raise pay for top-scale assembly plant workers, with increases and cost-of-living adjustments that would translate into 33% wage gains. Top assembly plant workers are to receive immediate 11% raises and will earn roughly $42 an hour when the contracts expire in April of 2028. Under the agreements, the automakers also ended many of the multiple tiers of wages they had used to pay different workers. They also agreed in principle to bring new electric-vehicle battery plants into the national union contract. This provision will give the UAW an opportunity to unionize the EV battery plants plants, which will represent a rising share of industry jobs in the years ahead.

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

2020 Dodge Challenger Drag Pak comes solely with supercharged power

The Dodge Challenger Drag Pak has returned for 2020, five years after the last one arrived, and two years after it began development. And while in many ways it looks like past Drag Paks, there are a number of tweaks that should make this the fastest and most capable factory drag car yet from Mopar. Unlike the last model, only a supercharged 354-cubic-inch (5.8-liter for the imperically challenged) V8 is available. Mopar says it's more powerful than its predecessor, though exact horsepower wasn't given. It did confirm that the previous car was capable of a stunning 1,200 horsepower. The engine is coupled solely to a three-speed automatic transmission with a manual shifter. 2020 Dodge Challenger Drag Pak View 17 Photos Supporting the massive engine are many chassis, suspension and driveline enhancements. The independent rear suspension and axles are gone in favor of a solid axle from Strange and a four-link suspension. The front remains stock except for double-adjustable Bilstein shocks. The engine is mounted to a subframe member that's beneficial both to weight distribution and center of gravity. The car gets high-performance brakes and custom Weld Racing wheels with "DRAGPAK" engraved on them. The interior features a welded-in roll cage certified for quarter-mile times as quick as 7.5 seconds. Helping keep the car planted without increasing drag too much are front and rear spoilers from the road-going Challenger, a new addition compared with the previous car. Every Drag Pak car also comes standard with a wheelie bar and parachute. Dodge will only build 50 of these cars, and they'll only be offered as race cars that aren't legal for the street. The cars will be eligible for competing in sportsman classes in NHRA and NMCA drag racing series. Pricing and availability hasn't been set yet, but will be revealed sometime next year.