2006 Dodge Charger R/t Sedan 4-door 5.7l Mechanic Special on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Dodge Dart getting hatchback variant... sort of

In other parts of the world, Fiat builds and sells a version of the Dodge Dart called the Viaggio, and it appears that in addition to the current sedan bodystyle, a new hatchback version of the car is also in the works. Autocar says that the general manager for China's Guangzhou-Fiat joint venture, John Burton, has confirmed that a new Viaggio hatchback will be revealed by the end of this year before it goes on sale in early 2014.
The Viaggio will soon be joined by the 2014 Jeep Cherokee, which in China will be called the Liberty Light, at the Guangzhou-Fiat plant. While the idea of a Dodge Dart hatchback might be enough to enable most of us to forget about the Dodge Caliber, a North American variant doesn't appear to be in the cards. We reached out to Chrysler PR boss Rick Deneau, and he offered a succinct: "No plans at this time."

Takata airbag recall claims 209k Chrysler, Dodge vehicles

Chrysler is expanding the scope of its front passenger side Takata airbag inflator recall yet again to include 139,115 additional vehicles for a total of 208,783 units now needing these parts replaced. The latest campaign affects the passenger side inflators of the 2003-2005 Dodge Ram 1500, 2003-2005 Dodge Ram 2500, 2003-2005 Dodge Ram 3500, 2004-2005 Durango; 2005 Dakota pickup; 2005 Dodge Magnum and 2005 Chrysler 300 (pictured above), 300C and SRT8. It's limited to vehicles purchased or ever registered in Alabama, Florida, Georgia, Hawaii, Louisiana, Mississippi, Texas and the territories of American Samoa, Guam, Puerto Rico, Saipan and the US Virgin Islands. The company expects owners to be notified by February 8. The automaker just expanded the replacement campaign last week to include passenger side inflators in 149,150 pickups from the 2003 model year. However, the parts are not the same. Chrysler says this recall is for the PSPI family of components versus SPI for the last one. The company is also not aware of any injuries or accidents in its vehicles from these potentially faulty inflators, and lab testing of 600 of them finds no issues. Despite this, Chrysler is repairing these models at the request of the National Highway Traffic Safety Administration. Scroll down to read the company's full announcement of the initiative. Statement: Air-bag Inflator (Regional Field Action Expansion) December 12, 2014 , Auburn Hills, Mich. - Chrysler Group is expanding an ongoing regional field action with a recall to replace front passenger-side air-bag inflators in an estimated 208,783 older-model vehicles originally purchased or ever registered in seven U.S. states and five territories. The vehicles are equipped with front passenger-side air-bag inflators from a product family code-named "PSPI." Chrysler Group is unaware of any injuries or accidents involving PSPI inflators of the type covered by this campaign, nor has a Chrysler Group investigation identified a defect in these components. Further, laboratory tests on nearly 600 such inflators did not result in any failures. The inflators affected by this campaign differ in design and construction from PSPI inflators used by other auto makers. They also benefited from a more robust manufacturing process. However, at the request of the National Highway Traffic Safety Administration (NHTSA), Chrysler Group is expanding its replacement action beyond its original scope of Florida, Hawaii, Puerto Rico and the U.S.