1972 Dodge Charger 2dht 318 V8 Auto A/c Barn Find on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

2018 Dodge Demon comes with a factory tune for race gas

We knew the Dodge Demon was going to make a lot of power, but the ongoing question has been how much. We've seen estimates of between 757 and 1,121, but those have simply been guesses based on the numbers found in promo photos. However, if we had to put our bets on a horsepower rating, we'll probably go with the higher estimates because the Demon can run on race gas. Yes, the latest teaser for the Demon reveals that it will come with a factory tune optimized for race gas, which is rated at 100 octane or higher. Running such high octane, in combination with its heavy-duty intake cooling, means the Demon can handle absurd amounts of boost and advanced timing without running the risk of dangerous pre-ignition or detonation. Of course this also means the Demon should be capable of astonishing power with the high-octane calibration. The tune will be included in the Demon crate on a separate engine computer that the owner can swap out when he or she is ready to race. In addition to the computer, the center stack also has a button to activate the high-octane mode. A pair of fuel pumps and larger injectors also ensure the engine gets plenty of that sweet racing fuel. When not running the high-octane tune, the Demon runs on your average premium gasoline. Also, in case you accidentally run premium gas with the high-octane mode activated, the car will automatically switch to the default tune if engine knock is detected. You can get a peek at the system in the video above, and be on the lookout for a bonus video tomorrow. The full reveal will be next week on April 11 at the New York auto show. Related Video:

1968 Dodge D200 'Lowliner' adds low-down diesel torque to a lowrider

When Mopar does a custom classic car, it's always spectacular, whether it's a Dodge muscle car like the 1,000-horsepower Super Charger or the monster Jeep Five-Quarter off-road pickup. For SEMA this year, Mopar skipped another Dodge sports coupe in favor of a 1968 Dodge D200 pickup truck done up as a lowrider, but with a twist. Or more accurately, with lots of twist. Under the gorgeous candy red metallic body is a 5.9-liter 24-valve Cummins turbodiesel straight-six. It makes an estimated 325 horsepower and 610 pound-feet of torque, and it's paired with a six-speed manual transmission. Representatives from Chrysler estimated the weight of the engine and transmission alone at 1,100 pounds. The diesel engine's power goes to the rear wheels, which are 22 inches in diameter and 11 inches wide with fat 325-mm tires. The front wheels are a tad narrower at 9.5 inches. 1968 Dodge D200 View 7 Photos As cool as the powertrain is, the exterior and the interior of the truck can't be ignored. This generation of Dodge pickup is already intriguing with its distinct character line with a little kink at the end and ribbed and louvered hood. These unique styling cues are accented now that Dodge removed various other details from the body such as the door handles, metallic trim and such. The bumpers were also reshaped to better fit the contours of the body, and the front wheels were pushed forward to reduce the long overhang of the stock truck. The bumpers, grille, and "smoothie" style alloy wheels were also painted in a solid cream color rather than chrome, which both accents the deep red body and gives the truck a more workmanlike feel, as low-trim cars typically had painted trim instead of chrome or stainless steel. The red paint also features subtle Cummins logos on the fenders and Dodge block lettering on the tailgate. The interior continues the simple and classy theme. The original bench seat remains, but with saddle brown leather upholstery. Leather trim has been added throughout, and exposed metal parts have been painted in the same color as the exterior. Simple gray cloth floor mats cover the bottom of the cab, and the instrument panel uses new Mopar gauges in a machine-turned metal housing. The original steering wheel remains, but a custom shifter with red Cummins shift knob sticks through the floor.