1968 Dodge Charger Original Big Block Car, Buckets / Console on 2040-cars

Auto blog

FCA recalls 570,000 SUVs from Jeep and Dodge over fire woes

Fiat Chrysler US has issued two recalls covering a total of about 570,000 Jeep and Dodge models. The first concerns vanity mirror wiring in the Jeep Grand Cherokee from the 2011 and 2012 model years, and in Dodge Durango units built before September 12, 2012. The automaker recalled almost 900,000 units last year to repair the issue, then faced more issues this year when the fires continued in repaired vehicles. This new recall seeks to resolve the issue, FCA saying that the post-recall fires happened in a tiny percentage of vehicles equipped with a specific wiring package. This recall is for 352,831 total units in the US, another 26,478 in Canada, 13,037 in Mexico, and 84,330 internationally. No injuries or deaths have been reported. FCA says it will inform customers as to when they can schedule a service visit to remedy the issue. The second recall takes aim at 60,107 examples of the Jeep Compass and Patriot from the 2015 model year in the US, plus 5,755 in Canada, 3,351 in Mexico, and 23,995 in other markets. Those models could suffer from an out-of-position clamp on the power steering fluid line. The error could allow fluid to leak, increasing the risk of a fire if the fluid ends up on a hot surface. In the case of a complete loss of fluid, drivers will need to use a lot more effort to steer. The automaker reports no injuries or accidents, and will advise customers when to head to the dealer for service. Related Video: Jeep Grand Cherokee and Dodge DurangoStatement: Vanity-Mirror WiringDecember 24, 2015 , Auburn Hills, Mich. - FCA US LLC is recalling an estimated 352,831 SUVs in the U.S. to help ensure vanity-mirror wiring may be serviced more consistently.Overheating conditions were reported among a small percentage of vehicles (<0.02%) serviced in connection with a related recall, conducted previously.** An FCA US LLC investigation discovered the service procedure, if not followed precisely, may leave vehicles susceptible to a short-circuit, creating a potential fire hazard.The Company is unaware of any related injuries or accidents. Post-service overheating conditions were observed only in vehicles equipped with a certain wiring package. These vehicles were produced before Sept. 2, 2012.Affected are model-year 2011-2012 Jeep Grand Cherokee and Dodge Durango SUVs produced before Sept. 2, 2012. Wiring in the headliners of these vehicles will be secured with a new adhesive.

This 93-car Iowa auction is like a Big 3 classic muscle museum

Bill "Coyote" Johnson has been buying cars since high school and has amassed a collection totaling 113 vehicles, according to NBC 6 News. But time has changed his motivations and priorities, and he's decided to auction 93 of those cars, many of which are classic muscle from Ford, Chevrolet, Dodge, Plymouth and Pontiac. The megasale will take place Sept. 14, 2019, in Red Oak, Iowa, at the Montgomery County Fairgrounds. A 1969 Plymouth Road Runner infected Coyote with a love for Detroit muscle when he was just a teenager, and his desire quickly turned into an obsession. He's spent the past 40 years finding, buying and working on a variety of makes and models. Unlike some collectors, Coyote didn't discriminate against certain brands and has rides from each of the Big 3 automakers. Included in the auction are Camaros, Satellites, Super Bees, Chargers, Challengers, Barracudas, Coronets, GTOs, Mustangs, Cutlasses and others. Possibly the most intriguing aspect of the auction is that all of these cars will be sold as-is with no reserve. Many of them will need work, depending on quality standards, but this seems like a golden opportunity to find a classic car without leaving a bank account in shambles.  The auctions are open for bidding online now, and the full auction will take place on September 14. Check out the full listings and bid at VanDerBrink Auctions.

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.