Auto V6 Alloy Wheels We Finance on 2040-cars

Auto blog

Dodge hoping Fast & Furious appearance gives Dart a sales jolt [w/video]

According to Automotive News, Chrysler is hoping Fast & Furious 6 will be kind to the Dodge Dart. While the compact sedan doesn't actually show up in the film, Dodge has partnered up with the movie franchise for a new ad featuring the Dart.
Chrysler hasn't exactly seen the high sales numbers it was originally hoping for with the new sedan, thanks in part to a couple of missteps. For starters, most early-production vehicles were only offered with a manual transmission. Analysts believe Chrysler squandered around 95 percent of potential Dart sales because automatic transmission options weren't immediately available.
Right now, the Dodge Dart rakes 19th among compact cars, pulling down 31,064 sales through April. Last month was the company's strongest, with 8,099 units moving off of dealer lots. Unfortunately, the model has also been handicapped by its older sister, the Avenger. With Chrysler throwing heavy incentives at the aging sedan, many consumers have taken advantage of a better deal with the slightly larger, more powerful Avenger.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Marchionne may stay with FCA until 2020

We might get to see Sergio Marchionne and his vast array of sweaters in the auto industry for even longer than expected. The FCA CEO suggested last year that he would retire from the automaker when its current five-year plan was complete in 2018. Now, he has tentatively extended that point out to at least 2020. "I can do this for another five years if you push me, right? Beyond that, I ain't gonna do it, and I don't want to," he said to Automotive News. That would give Marchionne a 16-year career at the top from joining Fiat in 2004 to possibly leaving FCA in 2020. Although, take the CEO's statement with a grain of salt because he has made multiple statements about the timing for his retirement. In 2012, Marchionne said he would only remain in charge until 2015, which is, well, now. Those five years might also go quite quickly because Marchionne is a busy guy with the Ferrari IPO, the attempted merger with General Motors, implementing FCA's five-year plan, and many other projects. He's already considering the next CEO, though. "My purpose in life is to find the Kuniskises of the world, the Manleys, the Biglands, the Palmers," Marchionne said to Automotive News, referencing the heads at Dodge, Jeep, FCA North America, and the company's chief financial officer, respectively. "I told them, 'One of you is going to do what I do one day. I don't know who that is, but one of you is going to do it.'" News Source: Automotive News - sub. req.Image Credit: Paul Sancya / AP Photo Chrysler Dodge Fiat Jeep Sergio Marchionne FCA fca us Mike Manley reid bigland tim kuniskis