2011 Dodge Challenger 2dr Cpe Srt8 Coupe 392 on 2040-cars

Auto blog

Dodge Grand Caravan, Journey no longer available in the California emissions states

The Dodge Grand Caravan and the Dodge Journey are no longer available for sale in California or any of the states that follow its emissions standards (often referred to as the ZEV states). As reported by Allpar.com, the 3.6-liter Pentastar V6 in the Grand Caravan does not meet those emissions standards for 2020, and evidently neither does the 2.4-liter four-cylinder that is the sole engine offering in the Journey this year. The Pentastar V6 used in other Dodges, Chryslers and Jeeps is an updated unit that does not face the same emissions issues. The 2020 model year already was due to be the last for the Grand Caravan, which is being replaced in the lineup by a lower-priced and lower-spec version of the Chrysler Pacifica called the Chrysler Voyager. Production of the Grand Caravan at FCA's Windsor, Ontario factory is reportedly due to end in May. As for the Journey, that model has exceeded its sell-by date and is the oldest entrant in its class. The vehicle was introduced as a 2009 model, and not has seen major revisions in the 11 years since. For 2020, Dodge has cut the Journey model lineup to just two trim levels: SE Value and Crossroad (dropping the SE and the GT), and it's front-wheel drive only. But the Journey could continue — in some states at least — into the 2021 model year. Rumors of its replacement, with a sportier model based on the Alfa Romeo Stelvio, don't have it arriving until 2022 or so.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Cruise Woodward Avenue with Autoblog's Dodge Challenger Hellcat

While Autoblog was consumed by coverage of the increasingly important Monterey Car Week last weekend, there was another big even going on. The Woodward Dream Cruise is significantly lighter in terms of news, but there's no denying that it's a far bigger, and far more egalitarian than what the wine-and-cheese crowd experience on the links at Pebble Beach. The Dream Cruise crams tens of thousands of cars and over a million spectators along a four-lane ribbon of asphalt between Ferndale and Pontiac, MI. What's remarkable aren't these numbers, though, so much as the distances they travel. Owners and admirers come from far and wide, across the United States and in some cases across the globe, to take in the spectacle. This year, local radio and television coverage featured fans that traveled from Japan, Australia, and Europe, just to take in the cruise. Of course, we realize that not everyone can make the pilgrimage to Woodward Avenue. With that fact in mind, we decided to bring a bit of the Dream Cruise to Autoblog with a time-lapse video of the cruise route. You can experience the good (a Lamborghini Gallardo, Chevrolet Chevelle, and Oldsmobile Cutlass 442), the bad (the traffic jams), and the ugly (no, your 2003 Ford Focus does not qualify as a classic, get the hell out of the cruiser lanes). So join us, as we turn off 8 Mile Road behind the wheel of our 2015 Dodge Challenger SRT Hellcat and run north, through Ferndale, Pleasant Ridge, Royal Oak, Huntington Woods, Berkley, Bloomfield Township, and Bloomfield Hills, before ending up on Wide Track Drive in Pontiac.