Find or Sell Used Cars, Trucks, and SUVs in USA

~ 2010 Dodge Challenger Srt8 Procharger Supercharger Hemi 525hp Supercharged ~ on 2040-cars

Year:2010 Mileage:24345 Color: Black interior
Location:

Shawnee, Kansas, United States

Shawnee, Kansas, United States
Advertising:

This listing is for the following:

2010 Dodge Challenger SRT8

Procharger

Silver exterior

Black interior

6 speed

521hp

483 torque

Kenne Bell Boost A Pump

Underdrive pulley

Cat back exhaust - not sure on make but it sounds good

Mopar billit cue ball shifter and short throw shifter



Recent work done to car last winter:

Hone block

Polish crankshaft

Resurface heads

Balanced

New engine kit that includes rings, bearings, head set, head bolts, lower gasket kit

8 brand new Mahle forged pistons

I am driving this car at times. So, the mileage might go up, but not an unreasonable amount.


Sorry about the black dot in the pictures. I took some new ones today hoping I cleaned off my lens, but noticed I failed. This is a very nice car!



I purchased this car in April 2013 with 16k miles as a personal fun 2nd car. It is always in my garage and driven by me. It ran good before the work, but I thought about doing a few things to the car as time/money allows. I am stoked about adding the forged pistons and glad I did. This will only help the longevity of the engine. I have put 4k miles on the car since the pistons were installed. The 1st 500 miles were very easy and changed the oil after and had it tuned and on the dyno machine. It sounds fantastic and runs great. I have workers next door who come outside everytime they hear it start. Anyway, I found a lifted truck I want now. So, I am putting the Challenger up for sale.

The flaws I have noticed on the car are:

Passenger window has a scratch to the left of the lock.  I can see it in the picture from top to bottom.  No idea how this happened.

Notice the light scratch on the drivers seat side to the left of the handle.  No idea how this happened.

There is a very small scuff on the drivers door edge.  I think I did this opening the door in my garage when it was tight next to another car.  It is not very big.

As you see, I try to disclose the bad even as minor as they are.  I am 100% honest and don't want any surprises.


No other issues

No surprises

I love the car and have no issues with it.  I was driving it daily in May and then parked it for a month.  Just took it out today for pictures and enjoy it.  The car was covered up all winter.  Be prepared for lots of rubbernecking from people. I am surprised how many people look, smile, give you the thumbs up and just talk at the gas station!!


If you are looking for another ProCharger car, check out my 2005 Corvette.


Please do not ask for the reserve price as I will not disclose.  This is an auction to sell so bid what you think is fair.  I think the reserve is priced fairly to sell the car.

Auto Services in Kansas

Victory Lane Auto Sales ★★★★★

Used Car Dealers
Address: 204 N Madison St, Prairie-Village
Phone: (866) 595-6470

Used Cars Kansas City ★★★★★

Used Car Dealers, Used Truck Dealers, Financing Services
Address: PO Box 15261, Mission-Hills
Phone: (816) 824-4290

Thoroughbred Ford ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Body Repairing & Painting
Address: 8501 N Boardwalk Ave, Merriam
Phone: (913) 782-7677

Sutton-Kauffman Transmission ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 501 N Poplar St, S-Hutchinson
Phone: (620) 662-8651

Summit Auto Body CARSTAR ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Body Shop Equipment & Supplies
Address: 2509 NE Independence Ave, Prairie-Village
Phone: (816) 524-3330

Steven Ford of Augusta ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 9955 SW Diamond Rd, Augusta
Phone: (316) 775-3673

Auto blog

VLF Force 1 V10 is a rebodied Viper priced like a Lamborghini

Tue, Jan 12 2016

It would appear that Henrik Fisker is done with hybrids. His latest project, called the Force 1, packs an oversized V10 engine with no electric assist in sight and all the environmental credentials of a herd of flatulent cattle. Alongside the Karma-based, Corvette-powered Destino, the Force 1 is the second product from VLF Automotive. Fisker has taken partnership in the new firm as chief designer alongside chairman Bob Lutz and CEO Gilbert Villarreal. The company isn't saying explicitly what the Force 1 is based on, but it doesn't take a CSI team to trace its roots back to the Dodge Viper. Never mind that it's being built in Auburn Hills – the same Detroit suburb where Chrysler is headquartered – or that it was jointly developed by Fisker and professional Viper racer and dealer Ben Keating. It also happens to be powered by an 8.4-liter V10, and there aren't many of those kicking around the industry. Instead of the Viper's 645 horsepower and 600 pound-feet of torque, the Force 1's ten-cylinder engine is optimized to deliver 745 hp and 638 lb-ft. That, according to VLF, is enough to send the coupe rocketing to 60 in 3.0 seconds flat, covering the quarter-mile in under 11 seconds on its way to a top speed of 218 miles per hour. The power is transmitted to the Pirelli PZero rubber through a six-speed manual, but VLF says it will fit it with an automatic at the customer's request. Around that massive engine and two-seat cockpit, Fisker designed a new shape that, for better or for worse, looks way more aggressive than the Viper's. The Force 1's proportions are tellingly super-snake, but the curves are replaced by some very angry-looking angles and vents. Its head- and taillights are ultra thin, and the deep-dish, split-four-spoke wheels seem to visually split the difference between the three-spoke wheels on the original Viper and the five-spoke alloys it wears today. If you doubted the Force 1's origins before, the interior ought to give it away, with its wide tunnel and familiar surfaces. Only VLF has refinished it in leather, suede, and Alcantara, all diamond stitched with contrasting thread to help position this as a more luxurious prospect than the Dodge. It even fit between the seatbacks place for two champagne bottles that we hope nobody would consider consuming before trying to handle that much power. Of course, none of this will come cheap.

Work at a Chrysler dealership, get free college education

Mon, May 4 2015

The cost of a college education in the US can put a student tens (hundreds, in some cases) of thousands of dollars into debt. FCA US wants to give its dealership employees a leg up, though, and the automaker is now offering a completely free education to them through a partnership with Strayer University. The workers can take any of the college's classes online or on campus through program called Degrees@Work. Currently, the offer is only available to employees Chrysler, Jeep, Dodge, Ram and Fiat dealers in the automaker's Southeast region, which includes Florida, Georgia, South Carolina, North Carolina, Alabama and Tennessee. However, a national expansion will happen before the end of the year, Strayer spokesperson Cristina Henley tells Autoblog. The program will cover all of the students' expenses, including their books, according to Henley. FCA US sees this partnership as a way to improve the talent of its workforce, retain employees longer and possibly attract people wanting to take advantage of this free education. "Many of our dealers have expressed concern over the availability of talent to fill open positions due to business growth and turnover in their stores, especially in metro markets," Al Gardner, the company's Head of Dealer Network Development, said in the Degrees@Work announcement. Strayer has about 40 programs available, including in business administration, accounting, marketing, and more, and the university offers associate's, bachelor's, and master's degrees. It will also give FCA US employees credit for their work experience to get them a diploma even more quickly. FCA US Dealers to Offer Employees No-Cost, No-Debt College Education FCA US teams with Strayer University to develop first-of-its-kind dealer program Degrees@Work program open to all employees of participating dealerships Employees can earn no-cost, no-debt degree through Strayer University All Chrysler, Jeep®, Dodge, Ram and FIAT dealerships may participate First phase of program rollout begins with dealers in the FCA US Southeast Business Center National rollout expected later this year May 4, 2015 , Auburn Hills, Mich. - Employees of Chrysler, Jeep®, Dodge, Ram and FIAT dealerships will have the unique opportunity to earn a no-cost, no-debt college degree through Strayer University's Degrees@Work program, developed in collaboration with FCA US LLC. FCA US is the only company in the automotive industry to offer the program.

Chrysler readying Hellcat V8 with Viper-like power

Tue, 21 May 2013

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.