2009 Dodge Caliber Sxt on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

Dodge revives Challenger T/A and Charger Daytona trims for 2017

Dodge is reviving the Challenger's T/A trim and the Charger's Daytona line for 2017. Introduced on iconic Woodward Avenue just days before the annual Woodward Dream Cruise kicks off, the new variants promise more performance hardware and sportier aesthetics. We'll start with the two-door. The Challenger T/A, available with either the R/T trim's 5.7-liter V8 or the fire-breathing 6.4-liter Hemi V8, is inspired by the Challenger T/As of old. That means a less restrictive, 2.75-inch active exhaust system and a conical Mopar air filter. But there's no clear bump in output – Dodge still lists the base 5.7-liter at 375 horsepower and the 6.4-liter model at 485 hp. But hey, they're going to look cooler. Unlike the Challenger Hellcat, which should have it as standard, Dodge is including a Satin Black hood on every Challenger T/A. In fact, Satin Black is a recurring theme on this Challenger's front fascia, roof, rear decklid, and T/A bodyside stripes. And yes, the 20-inch Mopar wheels are black, too – they're also an inch wider than normal. Dodge is offering the T/A in three different trims. The base T/A has everything we described above, while the T/A Plus adds some comfort features like heated and vented Nappa leather seats, an 8.4-inch UConnect system with Apple CarPlay/Android Auto, a six-speaker stereo, and a shortcut button for the Dodge Performance Pages. The T/A 392, meanwhile, adds the 6.4-liter V8, even wider wheels, and Brembo six-pot calipers. If you prefer smoking tires with four doors, there's the new Charger Daytona. No, there's not an enormous wing on the back. But Dodge added the same kind of engine/exhaust upgrades found on the T/A while upping the top speed from 135 to 150 miles per hour. Satin Black features prominently again, with hood and rear fender graphics. The roof is also black. Unlike the Challenger, Dodge is only offering two different versions of the Daytona – the 5.7-liter base model and the 6.4-liter version, called the Daytona 392. Prices for the Challenger T/A start at $38,485, including a $1,095-destination charge, while the T/A Plus adds $2,750. Adding the 392 means shelling out $45,090. For the Daytona, you'll need a check for $40,985 for the 5.7-liter or $46,090 for the 6.4-liter. Orders for the Charger Daytona open in September, while the T/A is a month later. Related Video:

How to turn a Dodge airport tug into a trail slayer

Sometimes, having a ton of fun requires takes a ton of work. Just nine days before the so-called Ultimate Adventure 2014, the folks behind 4-Wheel & Off-Road had 40 tasks to complete in order to turn the ratty truck pictured above into a machine that could excel on treacherous off-road trails while still being able to handle highway jaunts. Much of process behind the build was chronicled on the latest episode of Dirt Every Day.
The team's vehicle started life as a 1990 Dodge tug truck that spent part of its life hauling around airplanes. The builders hung on to the Cummins six-cylinder diesel, but they tossed out practically everything else for the project, with some seriously heavy-duty replacement parts for the transmission, transfer case, axles and a whole lot more. The process was certainly a ton of work, but the end result looks like a fantastic crawler.
Sure, it might have been easier to bring a truck that was already prepared, but where would the fun in that have been? Stay tuned until the end of the video for a few glimpses of the completed Dodge and peek at some of the punishment it goes through.