2014 Dodge Avenger Sxt on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Chrysler expecting up to 200,000 9-speed transmissions for 3 models this year

Striving for improved fuel economy, we already knew that Chrysler will begin using a nine-speed automatic transmission in some of its new products this year, but what we haven't known is that volume at which this gearbox will be used. According to Bloomberg, Chrysler CEO Sergio Marchionne has been quoted as saying that the automaker expects to sell close to 200,000 units equipped with this new transmission in 2013. Those gear-rich trannies will be spread out across three models, consisting of the redesigned Chrysler 200, the still-unnamed Jeep Liberty replacement and the Dodge Dart.
This transmission should play a pivotal role in making Chrysler vehicles more competitive in their respective segments. Just for comparison, one of the Dart's key competitors, the Toyota Corolla, still uses a four-speed automatic, and a previous report indicates that the next-generation 200 could get up to 38 miles per gallon on the highway, which is better than most non-hybrid midsize sedans on the market. Marchionne says that the new Jeep model is expected during the second quarter of this year, but there is no word as to when the new 200 or nine-speed Dart will debut, but clearly Dodge would like to have the transmission in its compact yesterday. As for that volume figure, it definitely doesn't seem out of reach since the Dart, Liberty and 200 combined for a total of more than 225,000 units in 2012.
How many more gears can we expect in future cars? Probably not many more, since the CEO of transmission-builder ZF, Stefan Sommer, previously stated that nine speeds was the "natural limit" for transmissions.

Dodge Journey gets more SUV-like look with new Crossroad model

Looking to play up its aging three-row crossover, Dodge will introduce a new model for its Journey franchise at next week's Chicago Auto Show. The 2014 Dodge Journey Crossroad will be a new trim level positioned between the SXT and Limited, and it will be distinguished from other Journey models thanks to a handful of styling add-ons.
Plucking a page right out of the appearance playbook of the Ford Explorer Sport, the Journey Crossroad gets a meaner, more SUV-like demeanor. The Journey has often straddled the line between tall wagon and crossover, but this new trim goes a long way toward skewing its visuals toward the utility vehicle end of the spectrum. That's thanks largely to the Platinum chrome exterior trim on its roof rails and side sills, unique fascias, smoked headlights and taillights and, of course, those black 19-inch wheels. Inside, the Journey Crossroad will get a similar treatment, with darker, Liquid Graphite accents throughout the cabin, and the model will also come standard with leather seats (which Dodge says are a new design), and Chrysler's giant 8.4-inch Uconnect screen.
The 2014 Journey Crossroad goes on sale this spring with a starting price of $24,995 (*not including $995 for destination) for the four-cylinder, front-wheel-drive model, but Dodge says that the model will also be offered with more power and capability from the optional 3.6-liter Pentastar V6 and all-wheel-drive. Scroll down for the full press release, and check back next week for our live coverage from Chicago.