2013 Dodge Avenger Se We Finance!!! Auto Clean Carfax Blk/tan Cruise on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2015 Dodge Challenger SRT Hellcat gets brace of new videos

Yesterday's big announcement focusing on the new Dodge Challenger SRT Hellcat had plenty of stuff going for it - information, pictures and the rabid enthusiasm that always accompanies such an eagerly anticipated reveal. What it was lacking, though, was a proliferation of videos of the new model.
Sure, yesterday's news came with one clip, but today, Dodge has come through with five videos. We've arranged them in what we think will be the most entertaining order, covering the powertrain, before moving on to exterior and interior design, then on to a full CGI dissection of the SRT Hellcat before capping things off with a piece on the non-supercharged Challenger SRT392.
Take a look below for all five videos, then head into Comments and let us know what you think.

Viper fans are at the Nurburgring to reclaim production-car speed record

With the outgoing generation of the Viper, Dodge missed a fabulous opportunity to set another Nurburgring lap record. The company did it, twice, with the previous-generation Viper ACR, but never went back with the latest ACR, and it definitely won't now that the car is being discontinued. This is why a group of Viper fans began fundraising back in January to take ACRs to the 'Ring for one more shot at glory. And, right now, that group is in Germany preparing for the attempt. The team made it thanks to support from GoFundMe donors, and sponsorship from Kumho Tires and Prefix, a design and prototype company based in Michigan. They're using two Viper ACR GTS-R commemorative-edition cars, which are appropriate for competing track cars since they have the same white-with-blue-stripes color scheme as Dodge's old Viper GTS-R racecars. The cars are supplied from ViperExchange and BJ Motors and equipped with Kumho Ecsta V720 tires. According to the group's Facebook page, the team has been practicing since Wednesday, July 19. A video posted today highlighted that the only mechanical issue so far has been an overheating problem that was solved with a new thermostat. Each car is running a different suspension setup for practice - one soft, the other hard - and they'll adjust them as needed. The plan is that both cars will use the same setup on the record attempt. To claim the record without any argument will require beating the 6:45.9 time set by the Nio EP9 electric car. Right behind it is the Radical SR8LM, which is technically street-legal, but not really a street car. It set a time of 6:48. As for true street cars with gasoline engines, the target the Viper team will really want to beat is the Lamborghini Huracan Performante, which pulled off a time of 6:52. You can track the team's progress at its Facebook page. Related Video: Image Credit: Dodge Auto News Motorsports Dodge Coupe Performance Supercars dodge viper acr nio ep9