2012 Dodge Avenger Se on 2040-cars

Auto blog

Dodge Demon makes so much torque, it needs stronger driveline parts

Torque is a lovely thing, a sweet and wonderful force that twists and pulls and can help propel a two-ton metal box forward at comical speeds. Torque is also fickle and will bend and break those same metal parts without a second thought, which is why the new Dodge Demon is compensating for its increased torque with some new re-engineered and reinforced parts. And there's software intended to combat wheel hop, which one of the most dramatic ways torque can break stuff. Week 8's video, "Race-hardened Parts," gives a hint towards what all these new parts can do. While we still don't know how much torque the Demon will throw out, we do know it's enough to warrant an upgraded prop shaft, half shafts, and a differential housing. The Challenger Hellcat, which is the basis for the Demon, makes 650 pound-feet of torque already. The new parts will go a long way toward making sure the work from the Demon's engine is properly translated into motion by those Nitto drag radials. The new prop shaft uses high-strength steel, heat-treated stub-shafts, and increases the tube thickness by 20 percent for a 15 percent increase in torque capacity. Additionally, Dodge says the upgraded differential housing allows for a 30 percent increase in torque capacity by using heat-treated A383 aluminum alloy and a higher strength shot-peened gear set. The 41-spline half shafts that deliver 20 percent increased torque capacity through the use of high-strength low alloy steel and 8-ball joints. In addition to the hardware, the Launch Assist software has been tuned to help alleviate wheel hop. Dodge says the Demon is the first factory production car that uses wheel speed sensors to detect hop and momentarily cut torque to compensate. This means a driver can keep their foot planted on the floor while the computer sorts out the traction. Previously, the best solution was to back off the throttle to manually cut the load. Finally, the Dodge Demon will offer a four-point harness mounting bar as an optional accessory. The part will be supplied by Speedlogix and fits in place of the deleted rear seat. Customers can install the bar without having to hack apart their cars to find a proper mounting point. Look for more teasers and info on ifyouknowyouknow.com in the lead-up to the Demon's debut at the 2017 New York Auto Show. Related Video: Image Credit: FCA Dodge Performance dodge demon dodge hellcat

From Maseratis to rental cars | Autoblog Podcast #511

On this week's podcast, Mike Austin and David Gluckman are in a huddle room (again), because the studio was already taken (again). We talk about the all-wheel-drive Dodge Challenger GT (again), as well as the Jeep Wrangler, Maserati Levante, Miata RF (again), and then David waxes poetic on mediocre rental cars (or similar). The episode wraps up with the traditional doling out of Spend My Money buying advice, with some input from an S2000 owner on advice discussed last time. The rundown is below. Remember, if you have a car-related question you'd like us to answer or you want buying advice of your very own, send a message or a voice memo to podcast at autoblog dot com. (If you record audio of a question with your phone and get it to us, you could hear your very own voice on the podcast. Neat, right?) And if you have other questions or comments, please send those too. Autoblog Podcast #511 Topics and stories we mention Dodge Challenger GT Jeep Wrangler Unlimited Maserati Levante Mazda MX-5 Miata RF Used cars! Rundown Intro - 00:00 What we're driving - 06:11 Spend My Money - 32:45 Total Duration: 55:30 Get The Podcast iTunes – Subscribe to the Autoblog Podcast in iTunes RSS – Add the Autoblog Podcast feed to your RSS aggregator MP3 – Download the MP3 directly Feedback Email – Podcast at Autoblog dot com Review the show on iTunes Podcasts Dodge Jeep Maserati Mazda Nissan mazda mx-5 rf dodge challenger gt

2015 Dodge Challenger SRT Hellcat revving is sonic bacon

This is the Dodge Challenger SRT Hellcat, and we're sure that by now, you know its stats, including over 600 horsepower from its 6.2-liter, supercharged V8. What, pray tell, does that blown engine sound like, though?
At least judging on the sonic strength of this video, it's very, very dirty. Honestly, it sounds unlike anything that's come out of the Chrysler Group in a long time, if ever. It's loud, almost brutally so, with a bark that few road-going V8s can match.
Of course, you should be the final judge here. Take a look and a listen at the two videos below, one of which comes from our friends at Cars.com that provides a nice look under the hood, and then let us know what you think of the Hellcat's singing voice in Comments.