2006 Dodge Viper Srt 10 on 2040-cars

Auto blog

Stellantis wants to trim 3,500 hourly U.S. jobs, UAW says

WASHINGTON — Chrysler-parent Stellantis NV wants to cut approximately 3,500 hourly U.S. jobs and is offering voluntary exit packages, according to a United Auto Workers union letter made public Tuesday. The automaker is looking to reduce its hourly workforce offering incentive packages that include $50,000 payments for workers hired before 2007, UAW Local 1264 said in a letter dated Monday posted on its Facebook page. Stellantis spokeswoman Jodi Tinson declined to comment. A person briefed on the matter said the figure might be lower than the figure cited in the UAW letter. In late February, Stellantis indefinitely halted operations at an assembly plant in Illinois, citing rising costs of electric vehicle production. The action impacted about 1,350 workers at the Belvidere, Illinois, plant that built the Jeep Cherokee SUV and resulted in indefinite layoffs. The automaker has warned it may not resume operations as it considers other options. The UAW letter said openings created by workers leaving would be filled by workers on indefinite layoff. Stellantis said in February that about 40,000 U.S. hourly workers were eligible for profit sharing. Last week, UAW President Shawn Fain said Stellantis' decision to idle the Illinois plant was "a flat-out violation" of the union's contract with the UAW and is unacceptable. The UAW will enter talks with the Detroit Three before labor contracts expire in mid-September. Earlier this month, General Motors said about 5,000 salaried workers accepted buyouts to leave the automaker. GM CEO Mary Barra said February job cuts of a few hundred jobs and the 5,000 buyouts "provided approximately $1 billion towards" a $2 billion cost cutting target. Ford Motor Co recently announced significant job cuts in Spain, Germany and other parts of Europe and in August said it would cut a total of 3,000 salaried and contract jobs, mostly in North America and India. Hirings/Firings/Layoffs UAW/Unions Chrysler Dodge Fiat Jeep Maserati RAM Stellantis

Takata airbag recall claims 209k Chrysler, Dodge vehicles

Chrysler is expanding the scope of its front passenger side Takata airbag inflator recall yet again to include 139,115 additional vehicles for a total of 208,783 units now needing these parts replaced. The latest campaign affects the passenger side inflators of the 2003-2005 Dodge Ram 1500, 2003-2005 Dodge Ram 2500, 2003-2005 Dodge Ram 3500, 2004-2005 Durango; 2005 Dakota pickup; 2005 Dodge Magnum and 2005 Chrysler 300 (pictured above), 300C and SRT8. It's limited to vehicles purchased or ever registered in Alabama, Florida, Georgia, Hawaii, Louisiana, Mississippi, Texas and the territories of American Samoa, Guam, Puerto Rico, Saipan and the US Virgin Islands. The company expects owners to be notified by February 8. The automaker just expanded the replacement campaign last week to include passenger side inflators in 149,150 pickups from the 2003 model year. However, the parts are not the same. Chrysler says this recall is for the PSPI family of components versus SPI for the last one. The company is also not aware of any injuries or accidents in its vehicles from these potentially faulty inflators, and lab testing of 600 of them finds no issues. Despite this, Chrysler is repairing these models at the request of the National Highway Traffic Safety Administration. Scroll down to read the company's full announcement of the initiative. Statement: Air-bag Inflator (Regional Field Action Expansion) December 12, 2014 , Auburn Hills, Mich. - Chrysler Group is expanding an ongoing regional field action with a recall to replace front passenger-side air-bag inflators in an estimated 208,783 older-model vehicles originally purchased or ever registered in seven U.S. states and five territories. The vehicles are equipped with front passenger-side air-bag inflators from a product family code-named "PSPI." Chrysler Group is unaware of any injuries or accidents involving PSPI inflators of the type covered by this campaign, nor has a Chrysler Group investigation identified a defect in these components. Further, laboratory tests on nearly 600 such inflators did not result in any failures. The inflators affected by this campaign differ in design and construction from PSPI inflators used by other auto makers. They also benefited from a more robust manufacturing process. However, at the request of the National Highway Traffic Safety Administration (NHTSA), Chrysler Group is expanding its replacement action beyond its original scope of Florida, Hawaii, Puerto Rico and the U.S.

The Dodge Demon isn't the only way to a 10-second quarter mile

The Demon's rear tires smoke, the front tires lift – and in under ten seconds (after having spent $85,000) you've covered a quarter mile. In short, we fully get the attention shown Dodge's SRT Demonstrator. With disruption the operative word of the times, it's good to see a representative of the movement coming from Detroit. The SRT Demon delivers disruption in spades. There is, however, a viable alternative – and it doesn't require getting on the list at your Dodge dealer. If you want to do 0-60 in under three seconds or the quarter mile in around 10, the folks at Honda, Kawasaki, Suzuki and Yamaha – with any of their one-liter superbikes – have you covered. The gestation of what we now know as the superbike came roughly a decade after the debut of the muscle car. It was in the early '70s, as emission and safety regulations – along with rising insurance premiums – decimated the ranks of Detroit's fastest that motorcycle makers found their magical, almost mystical momentum. Honda's CB750 four was arguably the first, followed soon by Kawasaki's Mach III and Z-1. After that, it was Katie-bar-the-door, with more horsepower offered by Japanese OEMs until, invariably, insurance premiums went higher and, during the last recession, 20-somethings couldn't get affordable loans or insurance. Today, Japan's Big Four are once again engaged in a horsepower war, fueled by the rising interest in MotoGP, along with the rising profits available when selling a $20,000 motorcycle. And if that $20,000 - $10K per wheel – seems high, simple math tells you it's less than half of what you'll spend per corner if buying Dodge's Demon. The specs tell the tale. The Demon, fattened by both its flared fenders and a platform dating from the George Bush administration, supports its 4,200+ pounds on a wheelbase of 116 inches. That's in contrast to Suzuki's GSX-R1000 – redesigned for 2017 – which puts its 443 pounds atop a wheelbase of just 56 inches. To maximize its Hemi-supplied 800+ horsepower, Dodge diverts the air conditioning from the Demon's interior to the engine, which makes racing on a summer evening (you guessed it) devilishly hot. On Suzuki's GSX-R1000 – or similarly-equipped superbikes – almost all of the air at 100+ miles per hour is directed at you. To further underscore the differences, know that the GSX-R1000 and its like-minded competition can turn a quick corner, while the Demon is hard-pressed to execute a U-turn at the end of a quarter-mile straightaway.