1994 Dodge Viper Rt/10 on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

The Dodge Demon's massive hood scoop sucks air like a jet intake

You know what they say about cars with big hood scoops? They usually hide big blowers. At least that's the case with the Dodge Demon and its 45-inch wide hood scoop, the largest ever fitted to a factory production car. The fifth Demon teaser, "Forced Induction," shows off the increased capacity of the car's air intake and the resurrection of the Air Grabber hood scoop on Dodge's upcoming quarter-mile killer. View 4 Photos As with previous teasers, few details have been given outside of the Subaru-trouncing scoop's dimensions. Dodge says the scoop drops air inlet temperatures by more than 30 degrees. Where the more pedestrian Hellcat only has one air catcher headlight, both inner lights on the Demon are used to feed in air. The hood itself appears to channel air in and to the right into a new airbox that appears to be fitted with a K&N-style filter. Dodge seems intent on preventing any asthma issues with the new car. Standing in front of the car might literally take your breath away. Outside of that, the images don't show any new cryptic messages like previous teasers, or at least none that we can spot. One thing we did notice was that the engine block appears to be painted red, not orange like on the Hellcat. Doing some back and forth comparison also shows that the supercharger appears to be the same size as the current one. Of course, this is all speculative, so if you spot anything, drop a note in the comments. Related Video:

The 2018 Dodge Challenger SRT Demon will come with a crate full of goodies

Dodge released its latest trailer for the upcoming 2018 Challenger SRT Demon, and it's all about the extra stuff that comes with the car. Each Demon will be delivered with a custom-painted crate, complete with metal serial tag with the car's VIN and the name of the owner. Inside the crate are 18 items, which will help make the Demon a dual-purpose vehicle. The company says that "each customer can decide at the time of order, or once they own the car, or even at a moment's notice that they want their car to favor street performance, drag strip performance, or something in between." Dodge announced that the crate contains matching spare wheels and Demon-branded tools. In the trailer, we can see some of the tools, including a jack, impact gun, socket wrench, and a tire-pressure gauge. We imagine that part of the plan is that owners can have an extra set of tires, perhaps some even stickier drag slicks, and have everything on hand to swap them out quickly. Dodge also revealed that it will include a "Demon Track Pack System" and "Direct Connection Demon Performance Parts." These items present more of a mystery, since the trailer only shows the wheels and tools. One of the official images (pictured above) shows the crate opened up, and what may be portions of a racing harness. So the Demon may include some safety parts that could be installed or removed to make it safe on track, or comfortable on the street for the driver and passengers. Assuming that any passenger seats are left in the car. Related Video: