2012 Dodge Ram 3500 Reg Cab Auto 4x4 Diesel Dually 35k! Texas Direct Auto on 2040-cars

Auto blog

Dodge Journey and Fiat Freemont engine-cover recall affects 350k CUVs

FCA is recalling 349,731 examples of the 2011-2015 Dodge Journey and Fiat Freemont worldwide to better secure their engine covers. Of these affected vehicles, there are 144,416 in the US, 43,679 in Canada, 46,231 in Mexico, and 115,405 elsewhere. About 10 percent of them are also still at dealers, according to the automaker. Only models with the 2.4-liter four-cylinder engine are affected by this campaign. According to the company, the engine covers on these vehicles can be dislodged, and this can pose a fire risk if the loose part comes in contact with hot exhaust components. Warning signs of this happening include a noise under the hood, burning smell or a light on the instrument panel. The problem was discovered after three incidents on rough roads in Chile, and there was one minor injury there. According to FCA US spokesperson Eric Mayne to Autoblog, there have been eight occurrences of this issue reported in the US, but these were all related to "heat damage." There have been no reported injuries here. To fix the problem, dealers will install new engine-cover retainers on the affected models. These repairs will begin in August. As always for recall repairs, owners won't be charged. Statement: Engine Cover July 22, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 144,416 crossover utility vehicles (CUVs) in the U.S. to better secure their engine covers. Engine covers in certain vehicles may become dislodged. If they come in contact with exhaust components, it may pose a fire risk. This condition was discovered during an FCA US investigation of three incidents in Chile. In each case, the vehicle had been driven extensively on unpaved or uneven surfaces. The Company is aware of a single related injury, described as minor. Affected are 2011-2015 Dodge Journey and Fiat Freemont CUVs equipped with 2.4-liter, four-cylinder engines. FCA US will install upgraded engine-cover retainers in these vehicles. The remedy will be available when customer notification begins next month; service will be performed free of charge. Vehicles equipped with six-cylinder engines are not affected. Additional Journey and Freemont populations also are subject to this campaign. They comprise an estimated 43,679 vehicles in Canada; 46,231 in Mexico; and 115,405 outside the NAFTA region. Of the 349,731 total vehicles subject to this campaign, approximately 10 percent remain in dealer hands.

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

No wing, no Hemi. This Dodge Charger Daytona is two-tone and tufted

In between the Dodge Charger Daytona's 1969 debut as a wild, winged NASCAR warrior and the current 2020 Charger SRT Hellcat Widebody Daytona 50th Anniversary Edition with its monster 717-hp Hemi V8, the nameplate had some ... less-glorious years. The nameplate first resurfaced in 1975, when the Charger moved into the "personal luxury" space as a riff on the Chrysler Cordoba. This 1975 Charger Daytona might not be the model's heyday, but damn if this clean machine, surfaced by Barnfinds.com, isn't striking in its own Me Decade kind of way. And this low-miles example is on offer right now on eBay motors. Outside, this dynamic Dodge sports two-tone silver and blue paint, alloy wheels with white-letter tires, and a power sunroof. Inside, we find high-backed split-bench seats with button-tufted vinyl (no "rich Corinthian leather" here). Raising the miles-long hood reveals a 400-cubic-inch, 4-bbl V8, which for 1975 packed 190 horsepower. A far cry from today's 717 horses, perhaps, but still an upgrade over the Charger's standard 360-cubic-inch V8. It may not be the car that pops immediately to mind when someone says, "Charger Daytona," but with less than 12,000 miles showing, this mid-Seventies example is a time warp to a lesser-known era for the marque.   Featured Gallery 1975 Dodge Charger Daytona Dodge Coupe Classics