We Finance!!! 2008 Dodge Ram 2500 Laramie 4x4 Auto Cummins Diesel Bluetec! on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Chicago Auto Show: The really big reveals from shows past

The 2024 Chicago Auto Show may seem like a shell of its former self, but it still holds the title of the largest consumer auto show in the United States. It didn't get that reputation simply by being efficiently produced or convenient for locals desperate for something to do in February — it earned it over decades of breaking automotive news and powerhouse reveals, eventually earning an informal designation as America's truck show.  2024 may be a down year for Chicago, but let's not forget all of the great things that have come out of it, historically. Here's a look at some of our staff favorites. Bet you didn't know about a few of these cars that were first revealed in the Windy City.    2008 Dodge Challenger SRT-8  I didn't just pick this one as a former Challenger owner, but instead to illustrate just how many cool Chicago debuts we take for granted. Chrysler often chose its home turf to debut new cars, so the few times its unveilings happened elsewhere tend to stick in our minds. The first Challenger SRT-8 was kind of garbage, if we're being honest. I mean, who buys a race-bred, V8-powered muscle car without a limited-slip differential? But the SRT-8 formula evolved over time into something truly special, and what we saw in Chicago was essentially the early version of the Scat Pack, which was ultimately very successful for Dodge. And who would have thought we'd be here, 15 years later, still talking about that debut? And still loving these big Mopars, flaws and all. — Associate Editor Byron Hurd SHO time in Chicago IÂ’ll always have a certain fondness for the return of the Taurus SHO at the 2009 Chicago Auto Show. Chicago has always leaned truck and van heavy for press reveals, but every now and then, as this list illustrates, something spicy would appear. The return of the SHO as a high-powered successor to the original that ran from 1989-1999 gave enthusiasts hope for FordÂ’s performance business, especially for sedans. With a 3.5-liter EcoBoost V6 packing 365 hp, all-wheel drive and five-spoke wheels, the SHO was a nice upgrade from the lower-rung Taurus models. It was a bit more sedate than the original SHOÂ’s Yamaha-sourced V6 that teamed with a five-speed manual transmission, but still a worthy response to the Chrysler 300, Dodge Charger and later the Chevy SS. The SHO — Super High Output — begat things like the Fusion ST and gave Ford solid four-door performance for the rest of the decade.

McLaren, Koenigsegg, Toyota, Ford, Dodge and Corvette Lego kits announced for 2021

Lego has announced a slew of car-themed sets for 2021. The six kits comprise nine vehicles and fall under the brick pusher's Speed Champion line of official OEM-licensed kits. News of their arrival comes from German toy retailer JB Spielwaren's pre-order listings, which show three single-car sets and three dual-car sets of matched marques. Starting with the McLaren Elva roadster, the kit consists of 263 pieces and is finished in blue. It seems to have a difficult time capturing the curves of the real-life Elva, but there's only so much you can do with a bunch of plastic blocks. Lego has made several other McLaren kits before, including the Senna, 720S, and a more advanced Senna GTR for the Technics line. Next up is the Koenigsegg Jesko, made up of 280 pieces and finished in white. Though the real-life Jesko is still curvy, this kit does a better job of replicating its aggressive maw, vents and cantilevered rear wing. Rounding out the single-car sets is the 299-piece Toyota GR Supra in yellow. This marks the first time Toyota has lent their license to Lego. Again, it struggles a bit to represent the curvy Supra, relying on printed details like logos and headlights to identify. On the other hand, the Chevrolet two-car does a stupendous job with the 1968 Corvette. The C3 is instantly recognizable as such. The C8-R race car it's paired with suffers from the same issues as some of the previous cars, though. The set contains 512 pieces, and funnily enough the C8 driver has short hair while the C3 driver sports a period-correct wavy mane. The next set is a 627-piece Mopar-themed pair, including a purple (Plum Crazy?) 1970 Dodge Challenger T/A and an SRT top fuel dragster. The race car is spot on, but the Challenger was probably tough to make given the width restrictions. It looks a couple of pegs too narrow compared to the wide proportions of the real deal. Last but not least, the Ford set contains a Bronco R and Ford GT Heritage Edition. Consisting of 660 pieces, the set does an excellent job of representing both cars. The GT looks faithful in its Gulf livery, and the Bronco R looks more like a real Bronco than the actual Bronco R race truck. All in all, it's always fun to see more Lego sets with real cars, and we're glad to see more manufacturers added to the roster. The single-car sets are recommended for ages 7 and up, while the double-car sets have an 8 years and up rating. Price in U.S.