Slt 5.9 4x4 Automatic, Power Windows Power Locks Am/fm/cd 8 Ft Bed Toolbox on 2040-cars

Auto blog

Mopar unveils Dodge Challenger Drag Pak [w/video]

Dodge is going drag racing, and it's doing it with an all-new version of the Challenger for NHRA's Sportsman class. FCA's Mopar parts and performance arm announced the new Challenger Drag Pak Friday, showing off a version with a 354-cubic-inch (that's a 5.8-liter, by the way), supercharged V8 and a 426-ci (7.0-liter), naturally aspirated V8 – both Hemis, of course – that can get the big coupes through the quarter-mile in "the eight-second range." While the two engines deliver similar performance, at their base, they're quite a bit different. The supercharged model uses a cast-iron block, while the 426 has aluminum for both the block and head. That said, both models get customized engine calibrations, and are mated to unique, race-spec automatic transmissions. But drag racing is about far more than just outright power. Mopar significantly updated the four-link rear suspension, adding a four-inch rear axle from Strange Engineering, along with an aluminum, nine-inch third member, while the rear-axle housing has been strengthened in general. Both the rear shocks and front struts can be adjusted for rebound and compression, too. Lightweight 15-inch wheels, meanwhile, are shod in super-sticky Hoosier drag radials, with nine inches of tread in back and 4.5 inches in front. The new Challenger Drag Pak should run the quarter-mile in "the eight-second range." In the cabin, there's an NHRA-spec roll cage, a Racepak gauge cluster, and a handsome pair of Sparco racing seats. Outside, supercharged models get blue decals, while naturally aspirated varieties get black stickers, although there's more to the new Challenger dragster's exterior than just its decals. Mopar tweaked the big-scoop hood, promising it's easier to get up to check on the engine, and the designers also added trailer tie-down straps in both the front and rear. While the dragster was the big news today, Mopar officials also announced the two enhanced Scat Pack kits for both the Dodge Charger and Challenger R/T. The 5.7-liter Hemi models gain an extra 56 horsepower and 30 pound-feet of torque in the Scat Pack 2 thanks to a new cam, valve springs, pushrods, and gaskets. The Scat Pack 3, meanwhile, adds 75 hp and 44 lb-ft, on top of the gains from the lower packages. That should be perfect for drivers who wish to snort in the face of their SRT 392-driving friends. The third stage adds a ported cylinder heads, as well as high-flow manifolds and catalysts.

FCA recalling 63k Jeeps, Vipers and Ram ProMaster City vans

Fiat Chrysler Automobiles has announced a pair of recalls cover nearly 63,000 vehicles. The bigger of the two actions covers manual-transmission-equipped vehicles from 2006, including the Jeep Liberty and Wrangler, as well as the Dodge Viper. FCA engineers uncovered that the clutch ignition interlock switches use a kind of wire that was part of a previous recall campaign. Because of this, the company said that affected vehicles may not start, although in rare cases, "if recommended starting procedures are not followed," the affected vehicles may lurch forward after turning the key. Those recommended starting procedures "include activating the parking brake, placing the shift lever in neutral and pressing the clutch pedal before turning the vehicle's ignition key." Recall number two affects the company's 2015 Ram ProMaster City cargo and passenger vans. Owners will need to report to dealers to have a piece of tape removed from the side-curtain airbags. The tape is added during assembly and in some cases, may not have been removed. That could prevent the airbags from deploying in the event of a crash. Just under 59,000 vehicles are included in the first recall, including 43,874 in the United States, 11,309 outside of North America, 2,944 in Canada and 706 in Mexico. The ProMaster City recall includes just over 3,900 vehicles. FCA claims it's unaware of any injuries, fatalities or accidents related to either recall and will perform repairs free of charge. Scroll down for the official press release on both campaigns. Related Video: Statement: Clutch Ignition Interlock Switch April 23, 2015 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary recall of an estimated 43,874 older-model U.S.-market cars and SUVs equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. The action follows an investigation by FCA US engineers that discovered these vehicles are equipped with switches that contain a certain type of wire implicated in a previous campaign. The wire, which was temporarily substituted by a supplier for the specified material, may break. As a result, the vehicles may not start, and in rare cases – if recommended starting procedures are not followed – a vehicle may exhibit unintended movement when its ignition key is turned. FCA US is unaware of aware of any related injuries or accidents involving this population of vehicles.

FCA adds 88k Dodge Challengers to Takata inflator recall

The Takata airbag inflator recall from FCA US is growing 88,346 vehicles larger in the US after the company's discovery of the faulty parts in the 2008-2010 Dodge Challenger. The affected examples have production dates between September 19, 2007, and October 29, 2010, and the coupes need the replacement components on the driver's side. According to chronology posted by the National Highway Traffic Safety Administration (as a PDF), the automaker was auditing the models covered under the campaign in July and "identified a population of vehicles that was inadvertently excluded." Initially, FCA believed these cars were using an unrecalled Takata inflator. The audit revealed that the affected cars indeed used a recalled version. As with the rest of the faulty parts, exposure to moisture can cause them to ignite too quickly during an airbag deployment and spray shrapnel at occupants. The problem has been linked to at least eight deaths worldwide and a vehicle fire in Japan. The Challenger wasn't previously part of FCA's 3.3-million unit national campaign or the subsequent expansion. According to FCA US the parts to complete the repairs in these Challengers aren't currently available. However, owners will be notified of the issue by mail starting August 14. They will receive a second notice when the parts become available. Related Video: RECALL Subject : Driver Side Frontal Air Bag Inflator May Rupture Report Receipt Date: JUL 10, 2015 NHTSA Campaign Number: 15V444000 Component(s): AIR BAGS Potential Number of Units Affected: 88,346 All Products Associated with this Recall Vehicle Make Model Model Year(s) DODGE CHALLENGER 2008-2010 Details Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2008-2010 Dodge Challenger vehicles manufactured September 19, 2007, to October 29, 2010. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture. CONSEQUENCE: In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death. REMEDY: Chrysler will notify owners, and dealers will replace the driver's frontal air bag inflator, free of charge. Parts to remedy the vehicles are not currently available. Interim notices will be mailed to owners beginning August 14, 2015.