2013 Ram 2500 4wd 4x4 4dr Mega Laramie Longhorn Leather Hemi 5.7l Gas New on 2040-cars

Auto blog

All hail the Hellephant, Mopar's 1,000-horsepower crate engine

It's shocking to say this, but the all-powerful Dodge Demon looks weak now that Mopar has unleashed the Hellephant. This crate motor makes 1,000 horsepower and 950 pound-feet of torque, and its name is a combination of the nickname for the old 426-cubic-inch Hemi V8 and, obviously, the Hellcat. This monster is a 426-cubic-inch version of the current third-generation Hemi V8 topped by a supercharger similar to what the Hellcat line packs. Everything is cranked up to — or perhaps, past — 11. The engine block is made of aluminum and weighs 100 pounds less than the equivalent iron block. All of the internals are forged. The stroke and bore have been increased. The supercharger produces 15 pounds of boost and displaces 3 liters; more than the 2.7-liter blower on the Demon and the 2.4-liter blower on the Hellcat. And as big and powerful as it is, it will still rev to 7,000 rpm. It's a thoroughly monstrous motor, but shockingly, it won't be that difficult to live with. For one thing, Mopar will offer a complete kit to get the engine up and running, including an engine computer, wiring harness and drive-by-wire throttle. It also runs on 93-octane pump gas. That's especially amazing considering the Demon engine "only" makes 840 horsepower, and that's on race gas with 100+ octane fuel. It also has us wondering what the Hellephant could make on racing fuel. The Mopar folks did say that there's room to add more power. Pricing wasn't announced for the Hellephant engine. The Hellcat crate engine retails at $19,350 directly from Mopar, so it's safe to assume that the Hellephant will go for more. The installation kit with the computer and harness will be an extra charge of likely over $2,000, based on the Hellcat kit. The engine and the kit will be available in the first quarter of 2019. Related Video: Featured Gallery Hellephant Crate Engine SEMA Show Chrysler Dodge Jeep RAM Performance dodge demon hellephant

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

Has Dodge stepped in it again with Scat Pack lawsuit?

Lawsuits are an unfortunate part of doing business in just about any industry, so the latest complaint filed by a California-based aftermarket firm against Chrysler would seem to be nothing more than business as usual. But this isn't the first time the two companies have sparred over this particular issue.
According to a report from Automotive News, the dispute revolves around the Scat Pack name that Chrysler first offered on the Charger, Coronet, Dart and Super Bee starting in 1968. Scat Enterprises, a manufacturer of crankshafts and other components for Dodges and other vehicles, sued Chrysler for using its name. A few years later the Scat Pack disappeared from the Dodge catalog.
Fast forward to August 2013 when Chrysler applied to register the Scat Pack name anew. The US Patent and Trademark Office turned down Chrysler's application, but the automaker proceeded anyway, unveiling new Scat Packs for the Challenger, Charger and Dart at last year's SEMA show.