2004 Dodge Ram 2500, 5.9l Cummins H.o. Turbo Diesel, 78k Miles, 2 Year Warranty on 2040-cars

Auto blog

Dodge engineers trying to shoehorn Pentastar into Dart?

The fact that the Dart's launch has been a pretty dismal affair isn't what we'd call secret. Judging by its mounting inventories and poor critical reception, Dodge's successor to its unloved Caliber has struggled since it hit the market. And while both of those are difficult problems to address, at least their cause is well known - the powertrain.
Even Fiat-Chrysler CEO Sergio Marchionne has acknowledged that the powertrain options in the Dart are substandard, admitting at January's Detroit Auto Show that the powertrains are "less than ideal." Leading with the 1.4-liter turbocharged four-cylinder found in the Fiat 500 Abarth left a bad taste in the mouths of consumers thanks to the laggy engine and dead throttle response (to say nothing of the manual and dual-clutch gearboxes that needed more refinement). The addition of the 184-horsepower 2.4-liter Tigershark in the Dart GT has helped matters some, but apparently Auburn Hills doesn't think it's quite enough.
If rumors are to be believed - get that salt ready - a possible solution may be in the works. A report from Allpar is claiming that Dodge is considering fitting a Pentastar V6 into the Dart's engine bay. As the Mopar-obsessed website points out, the critically acclaimed Pentastar is available in three different sizes - 3.0 liters, 3.2 liters and the original 3.6 liters. We don't get the 3.0 here in the US, but the 3.2 can be found in the new Jeep Cherokee and the 3.6 has been seemingly fitted to every model Chrysler can shoehorn it into.

Cruise Woodward Avenue with Autoblog's Dodge Challenger Hellcat

While Autoblog was consumed by coverage of the increasingly important Monterey Car Week last weekend, there was another big even going on. The Woodward Dream Cruise is significantly lighter in terms of news, but there's no denying that it's a far bigger, and far more egalitarian than what the wine-and-cheese crowd experience on the links at Pebble Beach. The Dream Cruise crams tens of thousands of cars and over a million spectators along a four-lane ribbon of asphalt between Ferndale and Pontiac, MI. What's remarkable aren't these numbers, though, so much as the distances they travel. Owners and admirers come from far and wide, across the United States and in some cases across the globe, to take in the spectacle. This year, local radio and television coverage featured fans that traveled from Japan, Australia, and Europe, just to take in the cruise. Of course, we realize that not everyone can make the pilgrimage to Woodward Avenue. With that fact in mind, we decided to bring a bit of the Dream Cruise to Autoblog with a time-lapse video of the cruise route. You can experience the good (a Lamborghini Gallardo, Chevrolet Chevelle, and Oldsmobile Cutlass 442), the bad (the traffic jams), and the ugly (no, your 2003 Ford Focus does not qualify as a classic, get the hell out of the cruiser lanes). So join us, as we turn off 8 Mile Road behind the wheel of our 2015 Dodge Challenger SRT Hellcat and run north, through Ferndale, Pleasant Ridge, Royal Oak, Huntington Woods, Berkley, Bloomfield Township, and Bloomfield Hills, before ending up on Wide Track Drive in Pontiac.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.