2002 Dodge Ram 2500 4x4 Slt V8 Quad Cab 1-owner Only 40k Pw/pl Auto Clean Rare!! on 2040-cars

Auto blog

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

The 2017 Dodge Charger Pursuit will always watch your back

Police cruisers spend the majority of their life parked and idle, waiting for the call to action. A parked car is a vulnerable one, especially when there may be incentive to disable or destroy that vehicle. FCA has worked with InterMotive, Inc., to supply safety technology that will detect movement behind the vehicle through the combined use of radar and the rear-view camera. Even better, FCA is putting this tech in every 2017 Dodge Charger Pursuit at no extra cost. According to InterMotive, the Officer Protection Package is designed to help awareness with an officer is parked and working inside the vehicle. The system will provide an alert if there is anyone moving behind the vehicle to ambush the officer. The system plugs into the OBDII port and is secured under the dash. The device can then be manually switched on. This triggers the rear parking sensors to activate and. If any movement is detected, the officer can look behind the car through the rear-view camera. The system will automatically lock the doors, roll up the windows and flash the taillights. No word on how much the system will cost for non-2017 vehicles, but it is available for order right now. Related Video: News Source: FCA Dodge Technology Police/Emergency

Hellcrate 6.2-liter V8 delivers plug-and-play Hellcat hype to SEMA

SEMA just provided another entry for the folder marked "What A Time To Be Alive," with Mopar's announcement of the "Hellcrate" 6.2-liter supercharged Crate HEMI engine. Enthusiasts have been desperate to upgrade their vintage rides with the woozy thrills provided by Dodge's Hellcat motor, so Mopar answered. The Hellcrate engine assembly ships in plug-and-play configuration, in specially designed packaging with "Hellcrate" logos. The assembly sells separately from the Hellcrate engine kit, the kit adding a powertrain control module, power distribution center, engine wiring harness, chassis harness, accelerator pedal, ground jumper, oxygen sensors, charge air temperature sensors, and fuel pump control module. The PCM comes programmed with the production-car engine's 707 horsepower and 650 pound-feet of torque. An optional front-end accessory drive kit contributes peripherals like alternator, power steering pump, belts, and pulleys. Don't bother trying to lash up a sleeper 1997 Chrysler Sebring, though; Mopar tuned the Hellcrate for pre-1976 vehicles and manual transmissions. The engine assembly retails for an MSRP of $19,530, and the kit wants a further $2,195. Mopar didn't announce pricing for the accessory drive kit. The engine and kit come with a three-year, unlimited-mileage warranty when bought together. The Mopar Hemi Crate website will be happy to take your orders as of now. For help envisioning the possibilities, stop by Fiat Chrysler's 15,345-square-foot SEMA booth to check out the Limelight Green, Hellcrate-powered 1970 Plymouth Superbird clone worked up by Mark Worman of Velocity's " Graveyard Carz." While you're there you might as well peep Worman's encore, a 1968 Plymouth GTX stuffed with Mopar's 392 Crate HEMI in place of the original 440 big block, and the 1937 Dodge pickup that swallowed a Mopar 345 Crate HEMI. Mopar's come a long way from its original product: antifreeze products. Tomorrow it'll be Jeep's turn to ring the SEMA bells, once the noise dies down from the Mopar-jacked Wrangler Switchback, CJ66 and Jeep Shortcut. You can watch the brand's presentation online at 7:26 p.m. ET/4:26 p.m. PT. Until then, we're going to work the angles on a Hellcrate-powered Plymouth Volare. The sedan, naturally. Because we're practical. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.