Very Nice Green Dodge Ram 98 4x4 on 2040-cars

Auto blog

2020 Dodge Challenger Drag Pak will debut at SEMA

Mopar fans have countless reasons to get hyped about the 2019 SEMA show. Speedkore is bringing a twin-turbocharged, all-wheel-drive Dodge Charger Hellcat Widebody, Mopar is bringing a done-up 1968 Dodge D200 "Lowliner," Ram is bringing a diesel 1500 overlander, and Jeep is bringing a custom off-road Wrangler. But the launch of the new 2020 Dodge Challenger Drag Pak might garner the most attention from the brand's most serious customers. Prior to the show, Mopar teased a photo and a short video clip, both showing a new Dodge Challenger from the overhead view. The white Challenger showed a wide blue stripe down the center of the car with two pinstripes along each side. "Powered by SRT" runs across the top of the windshield, and Mopar logos grace both sides of the car just beneath the side windows. Red decals run back from the rear quarter panels and connect across the rear of the car. It also has hood pins on the SRT Hellcat hood and a parachute attached the rear. There's a parachute because this is the factory turnkey drag-race-focused Dodge Challenger racecar. Mopar released no other information on what type of hardware the Drag Pak will be using, or what's under the hood, but the video gives a great preview of the exhaust note in full tire-smoke mode. As some Drag Paks in the past have dropped roughly 1,000 pounds from their production starter vehicles, the 2020 model will surely utilize plenty of weight-savings methods such as the removal of all interior comfort features that don't apply on the racetrack. Mopar has also previously altered the position of the engine and changed the wheelbase to the benefit of better weight distribution. Mopar is set to livestream the unveiling starting at 7:26 p.m. ET (that's 4:26 on the West Coast, which not coincidentally coincides the the displacement of the vintage 426 Hemi engine) on Nov. 5, 2019. Until then, check out the 2009, 2010, 2011, or 2016 Drag Paks.

Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission

What do the Chrysler 300, Dodge Charger and Ram 1500 all have in common? Yes, they're all Chrysler products, and two of them are based on the same platform. And we're sure you could find more similarities between them all, but the common trait we're looking at here is that, while they all come standard in rear-drive form, they're also available with all-wheel drive. And it's the transmission in those models that's the subject of the latest recall notice issued by the National Highway Traffic Safety Administration.
The output shaft on the eight-speed automatic transmission supplied by ZF to Chrysler for the AWD versions of the 300, Charger and Ram 1500 is apparently prone to fracture. That in the end could leave the vehicle without power and could, according to the NHTSA investigation, increase the chance of a crash. The vehicle could also roll away if even if left in Park without the handbrake applied.
That's why Chrysler is calling in 4,194 examples of those three models from the 2013 model year. Dealers will be responsible for inspecting the transmissions and, where necessary, replace the entire unit. See the full recall notice below for all the details.

Dodge delaying Challenger Hellcats ordered with satin black hood [UPDATE]

The new Dodge Challenger SRT Hellcat is one of the most formidable muscle cars on the planet. And it looks the part, too – especially with the optional satin black hood. But if you were one of the first customers to place an order for the 707-horsepower Mopar muscle car and specified the black hood on the options sheet, you may have to wait awhile. According to members of the Hellcat.org forum cited by Car and Driver, deliveries of certain Challenger Hellcats have been delayed without explanation. When these fanatic customers started looking into the issue, they realized that all of the delayed orders shared one thing in common: they all had ordered their Dodges with that optional black hood. Although an exact reason wasn't specified, those who ordered the black hood on their Challenger coupes were told that delivery was being pushed back to February. But some were reportedly informed by their local dealership that things could be moved along if they switched their order to a body-colored hood instead. It's not clear if the issue is a supplier problem, a paint booth issue at the factory, or something else entirely. We've reached out to Dodge for clarification, and will update this story when we hear back. UPDATE: Reached for comment, a Dodge spokesperson confirmed to Autoblog that the satin black hood "is not currently available for production" and that customers who ordered it "can opt to change their order to a body-color hood" or otherwise have their orders delayed until the option becomes available at a later date to be confirmed.