2012 Dodge Ram 1500 Quad Cab St on 2040-cars
Floydada, Texas, United States
|
2012 Dodge Ram 1500 Quad Cab ST, Running Boards, tonneau Cover, This truck runs & rides great. Needs nothing.
|
Dodge Ram 1500 for Sale
1997 dodge ram 1500 ext cab 4x4(US $5,999.00)
1998 dodge ram 1500 laramie 5.2 truck(US $2,500.00)
1998 dodge ram extended cab 4x4 pickup truck w/ truck cap(US $1,500.00)
Viper style dodge truck badass(US $9,200.00)
Dodge ram 1500 quad cab 6 1/2' bed lid blue excellent condition 76k miles used(US $5,500.00)
2004 dodge ram rumble bee hemi 5.7l black limited!(US $11,500.00)
Auto Services in Texas
Zoil Lube ★★★★★
Young Chevrolet ★★★★★
Yhs Automotive Service Center ★★★★★
Woodlake Motors ★★★★★
Winwood Motor Co ★★★★★
Wayne`s Car Care Inc ★★★★★
Auto blog
Chrysler says its 8-speed transmissions will save 700 million gallons
Thu, Jun 19 2014Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.
Speedkore AWD twin-turbo Carbon Charger, best birthday gift ever
Tue, Nov 5 2019The backstory the Speedkore Performance AWD twin-turbo Carbon Charger teased a couple of weeks ago might be cooler than the car itself. Alan Palermo commissioned the carbon-fiber-bodied Dodge Demon Speedkore brought to SEMA last year, the one that supplanted the 6.2-liter Hellcat V8's supercharger with twin 6875 Precision Billet T4 turbos. That blasted the Demon's usual 840 horsepower up to 1,400 hp at the flywheel, 1,203 hp at the rear tires, good for an 8.77-second quarter-mile time at 162 miles per hour. Palermo's older brother remarked, "He liked the car but was more of a four-door guy," so Alan commissioned the AWD Carbon Charger as a 65th birthday gift for his sibling. Speedkore worked with Magnaflow on the sedan, starting with a 2019 Charger Pursuit as a base. The Wisconsin tuner secured a 2020 widebody Charger from Dodge, then 3D-scanned the bodywork to create the molds reproducing most of the sheetmetal in pre-preg carbon fiber. The hood, bumpers, fenders, rockers, rear spoiler, and rear diffuser are all fashioned from the lightweight stuff. Beyond those Precision turbos laid in by Gearhead Fabrications, Speedkore installed a custom upper plenum, Boost Leash C02 progressive boost controller, custom Thitek heads, a Fore Innovations triple-pump fuel system feeding Injector Dynamics 1,700-cc injectors, and custom HP Tuners engine software calibration. Test results showed 1,525 hp at the crank when running 26 pounds of boost. Hellraiser Performance engineered a new transmission working an FTI torque converter at one end and a carbon fiber driveshaft at the other. Instead of fortifying an off-the-shelf AWD system, Traction Products supplied a custom transfer case machined from billet shunting power to a set of Bogart Competition Series wheels wearing Mickey Thompson ET street rubber. Speedkore fitted last year's Demon with a front-exit twin exhaust, with a single opening on each front fender, and left the rear bumper cutouts for the traditional exhaust empty. With the Carbon Charger sedan more of a family guy, Magnaflow sorted out a quad-pipe front-exit exhaust with two openings on each front fender, and ran a three-inch stainless steel Competition Series exhaust to the rear. The driver can switch between the two, the latter version providing a "moderate interior sound." The folks at Speedkore say they'll keep tweaking the Carbon Charger after the show to get it right for the senior Palermo. We say, "Happy birthday, sir. Enjoy."
Weekly Recap: Toyota propels hydrogen fuel cells
Sat, Jan 10 2015Toyota is serious about hydrogen fuel cells, and it wants the auto industry to follow suit. The Japanese automaker said this week it's releasing 5,680 fuel cell patents from around the world, including technologies used on its upcoming sedan, the 2016 Mirai. The move is unusual, but not unprecedented, as Tesla similarly released its electric vehicle patents last year. The idea for Tesla, and now for Toyota, is to spur development of alternative propulsion. "By eliminating traditional corporate boundaries, we can speed the development of new technologies and move into the future of mobility more quickly, effectively and economically," said Bob Carter, Toyota Motor Sales senior vice president of automotive operations, in a statement. Toyota's fuel cell patents will be free to use through 2020, though patents related to producing and selling hydrogen will remain open forever. Toyota said it would like companies that use its patents to share their own hydrogen patents, but won't require it. "What Toyota's doing is really a logical move, and really a good move for the industry," Devin Lindsay, principal powertrain analyst with IHS Automotive, told Autoblog. The announcement was made at the Consumer Electronics Show in Las Vegas. It comes as Toyota prepares to launch the hydrogen-powered Mirai in a limited number late this year in California. The launch will be extended to the Northeastern United States next year. Toyota also has announced plans to support networks of fueling stations in each region to try to smooth consumer adoption. The Mirai has a 300-mile range on a tank of hydrogen, and it takes about five minutes to refill. Fuel cells have been receiving increased attention recently, and Audi and Volkswagen debuted hydrogen-powered cars at the 2014 Los Angeles Auto Show. Honda, another proponent of the technology, also showed its updated FCV concept in November in Japan. The company, however, has delayed its fuel cell sedan a year until 2016. Like Toyota, Honda says its hydrogen-powered car will have a range of 300 miles or more. Meanwhile, Hyundai currently offers leases for fuel-cell powered Tucsons, which have a 265-mile range, in Southern California. Despite the optimism some automakers have for fuel cells, the technology still faces barriers. A lack of filling stations has long held it back, and many consumers are not familiar with the potential benefits.










