2009 Dodge Ram 1500 Trx on 2040-cars

Auto blog

Dodge Charger SRT Hellcat in the works

In Autoblog's recent First Drive of the 2015 Challenger SRT with the 707-horsepower Hellcat V8 we found its engine to be as brutally powerful as the numbers would suggest, even if it wasn't the best handler. However, the muscle-car-styling just isn't right for some buyers that need four doors and proper rear seats to haul around the family. It appears that Dodge has their backs, though, because the Hellcat is very likely on its way into the Charger in the near future. Imagine the looks on your passengers' faces when you stomp down on the throttle.
According to Road and Track, when Dodge submitted the Hellcat for engine power certification to the Society of Automotive Engineers, the company included the Charger on the paperwork. That showed that the automaker wanted the engine checked out for the sedan, too. R&T reckons the 707-hp Charger would hit the road about a year from now, clearing the Challenger for a year of exclusivity with the powerplant.
When the Charger SRT Hellcat does hit the road, it may carry a very special accolade. Assuming nothing beats it in the meantime, it might be the world's highest horsepower production sedan. Think on that for a second. Even a Mercedes S65 AMG only has 621 horsepower, though a good bit more torque at 738 pound-feet to the Dodge's 650 lb-ft. So while the beastly engine is getting put into other models, where else would you like to see it? The Ram? Grand Cherokee? Let us know in Comments.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Marchionne nixes talk of a reborn Dodge Viper

UPDATE: According to Automobile Magazine's Todd Lassa, FCA chief Sergio Marchionne shot down the idea of a reborn Viper, saying "it's not in the plan." Marchionne was referring to Fiat Chrysler's five-year plan, which we've been covering in bits and pieces as the news filters out. But it's not out of the realm of possibility, apparently, as Marchionne reportedly said he'd be happy to see the reptilian supercar back in production. And it's not all bad news, anyway. A reborn Alfa Romeo 8C will get a carbon-fiber chassis holding a mid-mounted twin-turbo V6. With more than 700 horsepower, including an electrically-driven front axle, the car should hit 62 mph in fewer than 3 seconds. Also, three versions of a Maserati Alfieri will be produced, including a convertible. An electrified all-wheel-drive powertrain is planned. So, performance is coming from FCA, it just may not be from Dodge. View 36 Photos First came the mourning for the Dodge Viper, which ended production last year. Then came the Viper's continued sales run as a "Zombie Car;" we just wrote about how the Viper has racked up 11 sales so far this year, two of them in April. Now Car and Driver reports that the two-seater snake will return shorty for its second encore after being discontinued in 2009. The mag isn't equivocal about it, either, writing, "trust us: A new Viper is happening." It won't, however, be the same Viper that brought ten-cylinder brass knuckles to shake down other coupes for their wallets and jewelry. CD says we should expect the same front-mid-engine layout and rear-wheel drive tucked into a new spaceframe. That engine will lose two cylinders, with Chrysler's next-gen, aluminum-block V8 Hemi slotting into the engine bay. The previous Viper's V10 had grown to 8.4 liters and 640 horsepower by the time it drove into the sunset. CD guesses the coming Viper will start with a naturally-aspirated version of the Hemi V8 working up around 550 horsepower. Healthy doses of aluminum and carbon fiber would restrain the car's weight, on top of the weight loss from swapping an iron V10 for an aluminum V8. SRT could tart up the horsepower with a few performance trims, before a supercharged V8 with 700-plus horsepower arrives at some point after launch. The mag also suspects the initial offering will be a convertible, the hardtop appearing "a few years after launch," which could coincide with the more powerful engine. A row-your-own shifter will sit between the seats.