2009 Dodge Ram 1500 Slt Crew Cab Pickup 4-door 5.7l on 2040-cars

Auto blog

Dodge to sell off first Challenger SRT Hellcat for charity

Want to get your hands on a new 2015 Dodge Challenger SRT Hellcat, and can't wait to be the first to get one? Las Vegas will be the place to be on September 27. That's where Barrett-Jackson will auction off the very first example. And you'd better bring your checkbook, because the bidding is sure to be fierce with all the proceeds going to charity.
The supercharged Challenger with VIN 0001 has been hand-painted in Stryker Red (usually reserved for the Viper) and features special badging, documentation and accompanying memorabilia - not to mention, of course, that 707-horsepower, 6.2-liter supercharged Hemi V8. The car will be on display this weekend as well at Barrett-Jackson's Hot August Nights auction in Reno.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2016 Dodge Viper ACR First Drive [w/video]

The Dodge Viper is not a comfortable car. Livable, yes. The interior is covered in fine materials. But you still climb over a hot door sill to enter the tiny cabin. And the frequency range of the engine's noises seem specifically designed to cause headaches. What happens, then, if you remove all pretense of civility from a Viper and add equipment solely aimed at improving lap times? You would have the 2016 Dodge Viper ACR. In terms of achieving its purpose, this car is a absolute success. In many ways it's also the most honest Viper of the current generation. Prices start at $121,990 (including $2,100 gas-guzzler tax and $1,995 destination), or $32,900 more than the least expensive Viper. In ACR trim, the Viper loses the under-carpet padding, 9 of 12 speakers plus amplifier, carpet and trim from the cargo area, and sound deadening in front of the rear wheel wells. The parts of the interior still covered add healthy amounts of Alcantara or optional carbon fiber. That weight loss is compensated by the addition of go-fast bits like the giant rear wing (or the larger "x-wing" on the Extreme Aero Package), 10-way adjustable Bilstein Motorsports shocks, Brembo carbon-ceramic brakes, a rear diffuser, and a front splitter. Total claimed curb weight is 3,392 pounds in Aero trim (standard ACR trim is 18 pounds lighter), which is within a few stone of the rest of the Viper lineup. The diffuser strakes and leading edge of the splitter are removable, made to be replaced after rubbing on track tarmac and make street driving slightly more practical. Not that you'd want to drive the ACR on the street, with the lack of noise insulation and spring rates twice as stiff as the Viper TA, but it is street-legal. Dodge claims the DOT-approved Kumho Ecsta V720 tires on the ACR allow faster lap times than some race compound tires. Our test was limited to on-track shenanigans at Virginia International Raceway. Which is fitting because we wouldn't have anything good to say about driving the car on the street. The ACR is, essentially, a race car sold in the showroom, although with the Viper's 1 of 1 customization program, your custom build can include as many creature comforts as you like. Lined up in pit lane at VIR, the Viper ACRs for our evaluation blur the air with heat shimmer. All of the test cars have air conditioning, but that shuts off at full throttle with a six-second reset.