1939 Dodge Truck on 2040-cars

Auto blog

121k Dodge Darts being investigated over braking problem

The National Highway Traffic Safety Administration is investigating the Dodge Dart due to reports of braking problems. Some 121,000 cars are possibly affected, all from the 2013 model year. According to The Detroit News, NHTSA received 18 complaints about the brake pedal becoming hard to depress on these cars, increasing stopping distance. Drivers reported hearing a "pop noise or an air hissing noise when applying the brake pedal, followed by a hard pedal feel and reduced brake effectiveness," NHTSA told the News. In a particularly terrifying incident, one driver says the Dart's braking system shut down while driving at 50 miles per hour. "I feared for my life. It is one of the scariest things I have ever dealt with," the complaint said, according to The Detroit News. A Fiat-Chrysler spokesperson said the automaker is "fully cooperating" with this investigation.

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

Special Dodge Challengers get Hellcat bits to celebrate Mopar's 80th birthday

This year, Mopar is celebrating its 80th anniversary, and it's doing so in two-tone style with this very limited edition Dodge Challenger. Only 160 of these Challengers will be built, with 80 in each paint scheme. Buyers can choose between either Billet Silver or the slightly painful sounding Contusion Blue, each of which gets a hand-painted Pitch Black top half. These Challengers are based on the existing 392 Shaker package, but come with an array of upgrades and tweaks. In addition to the custom two-tone paint, the shaker scoop and rear spoiler are painted in the same color, rather than the usual matte black. The cars come with 20-inch wheels and hand-painted 392 logos on the fenders. The 392 cu. in., or 6.4-liter if you prefer, engine produces the same 485 horsepower and 475 lb-ft of torque as its normal counterpart. This Mopar Challenger will have more access to cold air, though, since it has both the shaker scoop and the headlamp intake from the Challenger Hellcat. At the back, there's also exhaust tips borrowed from the most hellish of Challengers. Or at least the most hellish, so far. View 14 Photos Inside, the changes are more minor. Performance seats are added with embroidered Mopar logos in the backrests. The seats and other trim also feature a silver-colored Tungsten stitching. Naturally, a serial number badge makes an appearance inside, too. Owners will also receive a little box of goodies including a booklet, signed rendering, keychain, additional badge, and a certificate showing the date of manufacture. The overall package is rather attractive, but it isn't cheap. To own one of the few Mopar Challengers, you'll have to fork over $56,885. That's a significant premium over the 392 Scat Pack Shaker, which starts at just $44,890 and makes just as much power. You'll also be able to get a 392 Scat Pack Shaker right away, while the Mopar special edition won't be out until spring. Plus, you may not get it until summer because the hand-painting process takes some time. Of course, for some people, the cost and the wait are worth the exclusivity. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.