1957 Dodge D-500 Hemi V-8 Sierra Station Wagon Mopar (desoto Chrysler) 58 59 on 2040-cars

Auto blog

NHTSA investigating 110,000 Ram 2500s and 3500s, one death alleged

The National Highway Traffic Safety Administration has launched an investigation focusing on 110,000 Dodge Ram 2500 and 3500 pickups from model years 2004 to 2006. One death has already been reported, according to NHTSA, due to a potential fault with the clutch interlocks on manual-transmission versions of the heavy duty pickup.
According to the report, these trucks can be started without depressing the clutch. There have been three reports so far, and as we mentioned above, one very sad incident seems to have resulted in the death of a child.
"One complaint involved an incident that occurred when a child was able to enter the vehicle and start the ignition without depressing the clutch. The vehicle then moved forward striking another child resulting in a fatality," NHTSA said in the investigation bulletin, which you can view below.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Charger SRT Hellcat in the works

In Autoblog's recent First Drive of the 2015 Challenger SRT with the 707-horsepower Hellcat V8 we found its engine to be as brutally powerful as the numbers would suggest, even if it wasn't the best handler. However, the muscle-car-styling just isn't right for some buyers that need four doors and proper rear seats to haul around the family. It appears that Dodge has their backs, though, because the Hellcat is very likely on its way into the Charger in the near future. Imagine the looks on your passengers' faces when you stomp down on the throttle.
According to Road and Track, when Dodge submitted the Hellcat for engine power certification to the Society of Automotive Engineers, the company included the Charger on the paperwork. That showed that the automaker wanted the engine checked out for the sedan, too. R&T reckons the 707-hp Charger would hit the road about a year from now, clearing the Challenger for a year of exclusivity with the powerplant.
When the Charger SRT Hellcat does hit the road, it may carry a very special accolade. Assuming nothing beats it in the meantime, it might be the world's highest horsepower production sedan. Think on that for a second. Even a Mercedes S65 AMG only has 621 horsepower, though a good bit more torque at 738 pound-feet to the Dodge's 650 lb-ft. So while the beastly engine is getting put into other models, where else would you like to see it? The Ram? Grand Cherokee? Let us know in Comments.