2014 Dodge Journey Crossroad on 2040-cars

Auto blog

Watch these Dodge Demons explode on a Texas drag strip

The Dodge Challenger SRT Demon is extremely quick. It can hit 60 mph from a dead stop in less time than it takes to read this sentence thanks to its supercharged 6.2-liter V8. That engine makes up to 840 horsepower and 770 pound-feet of torque, depending on what octane is running through the fuel lines. That's a ton of power going solely to the rear wheels. So much so that Dodge developed a number of features and a new set of tires specifically for the car. In our time with the Demon, the car took abuse run after run on a drag strip without skipping a beat, but it seems some actual owners aren't quite so lucky. Just take a look at what happened to a few of these cars. You can see the whole car shake and jitter right as the whole rear explodes in front of the tree. It seems the initial shock from the launch — the most taxing bit of any drag run — is what kills the differentials. Catastrophic failure is rarely pretty, but it is neat to see the whole thing occur in slow motion. Three more cars — four stock and one modified in total — suffered similar fates. Not a great look for Dodge or SRT. According to The Drive, a private drag event in Texas drew a number of Demon owners all trying to beat NHRA NHRA Top Fuel racer Leah Pritchett's time in her personal Dodge Demon — 42 stock Demons attended along with five modified cars. While no one managed to match her 9.65-second quarter-mile run, a few owners did dip below 10 seconds. Now, there are a few of caveats we must address. First, with any modified car, you run the risk of breaking something, even with a car that's set up from stock specifically for drag strips. Even a set of tires like the Mickey Thompsons shown in the video above can have an effect on driveline components. Horsepower may be king, but it's torque that's the rear killer. All that torque sends a shock through the car. Adding even more with aftermarket parts increases the risk of something failing. The modified car was apparently pushing out about 1,000 horsepower. That said, four of the five vehicles were stock, so any extra power or torque should theoretically be a non-factor. The drag strip's surface was maintained by a company called Mass Traction. FCA used Mass Traction during the Demon's development, so that too should be a non-factor in the part's failure. It's unclear what exactly caused the failures, though The Drive reports that FCA officials are investigating the matter. Related Video: This content is hosted by a third party.

2018 Dodge Challenger Demon, 1970 Charger become Lego cars

As much as we all would have loved to buy one, Dodge made sure that it wouldn't be easy for everyone to own a 2018 Dodge Challenger SRT Demon. It was only built for one model year, with a total of 3,000 units, and the last one was built last summer. And even if they were still available, each one started at just under $85,000, a substantial chunk of change. But thanks to Lego, there's a comparatively cheap way to get a new Demon: in tiny brick form. The toy company has added another kit to its Speed Champions line featuring a yellow Challenger Demon. Since the Speed Champions cars are quite small, it's a somewhat rough facsimile of the car, but it's still instantly recognizable. It's blocky, it has a big hood scoop and fat fender flares. It also has two sets of wheel covers to customize it. This kit has an advantage over a real Demon, too: it comes with a second car. The other one is a 1970 Dodge Charger in black. This is an even more faithful rendition, thanks in part to the real car's ruler-straight lines. It doesn't have customizable wheels, but you can choose whether to leave it stock, or stick on a little replica of a supercharger and hood scoop that poke through the hood. It ends up looking like Dominic Toretto's Charger from The Fast and the Furious. Besides the second car, the kit features a drag strip starting tree. It doesn't light up, but it does have a slider on the back that lifts up each set of colored bricks as it's pressed down. So you can have little drag races with the two cars. In total, everything is built with 478 pieces, and it will cost you $29.99. The kit is available now wherever Lego kits are sold, and even at the Dodge merchandise website. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.

Fiat Chrysler recalls 650,000 Dodge, Jeep SUVs for brake issue

Fiat Chrysler Automobiles said Tuesday it's voluntarily recalling nearly 650,000 Jeep Grand Cherokee and Dodge Durango SUVs to ensure that brake-booster shields were properly installed. The recall affects mostly vehicles sold in the U.S. but also roughly 60,000 combined in Canada and Mexico. The shields were installed in 2014 in conjunction with a recall involving the same set of vehicles, which cover the model years 2011 through 2014. A review of warranty data led to an FCA U.S. investigation that discovered the problem. FCA says it is aware of one potentially related accident, but no injuries. The shields are designed to keep water away from the boosters, lest it cause corrosion or freeze in cold temperatures and negatively affect brake performance. Brakes will still function even if boosters are compromised by water, FCA says, but drivers may experience brake-pedal firmness. In some cases, a potential booster issue may trigger a warning light or activation of the anti-lock brakes. Customers who've observed any of those conditions are urged to contact their dealers. The automaker says it plans to notify affected owners that free service to check and repair the issue if necessary will be available in early November. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Recalls Dodge Jeep Safety SUV FCA