2014 Dodge Grand Caravan Sxt on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Dodge could enter Peugeot's Le Mans-bound 9x8 hypercar in IMSA races

Fiat-Chrysler Automobiles (FCA) and PSA Group merged under the Stellantis umbrella in early 2021 to achieve economies of scale, and this benefit could surprisingly extend to racing. Executives are debating whether to give Dodge its own version of Peugeot's recently-unveiled 9x8 hypercar to race in America, according to a recent report. "While we only heard [the new rules] confirmed a week ago, it has certainly led to some very open discussion, not only about whether Peugeot might add races in the United States, but also about whether the spine of this car might have opportunities with other brands in the Stellantis Group. There are no conclusions yet, but there are now open discussions," affirmed Jean-Marc Finot, the Senior Vice President of Stellantis, in an interview with Racer. His comments refer to an agreement signed in July 2021 by the Automobile Club de l'Ouest (ACO), the Federation Internationale de l'Automobile (FIA), and the International Motor Sports Association (IMSA). They chose to align their technical regulations to let manufacturers compete in different events on both sides of the pond without going through the resource-consuming process of developing a specific car for each series. As of writing, the Le Mans Hypercar (LMH) and Le Mans Daytona h (LMDh) categories fall under the newly-announced common set of rules. On the surface, this means Peugeot could enter its 9X8 (pictured) in the WeatherTech SportsCar Championship as soon as the 2023 season. While this is seemingly under consideration, Peugeot has little to gain from winning a major race in the United States. It hasn't sold cars here since 1991, and its long-mooted comeback was canned after PSA merged with FCA. Giving a variant of the 9X8 to Dodge is a more credible possibility, according to Racer. If not Dodge, then who else? Chrysler hasn't been linked to racing or performance for decades. Jeep is no stranger to performance vehicles, but IMSA would be pushing it. Ram is Ram, while Fiat, Alfa Romeo, and Maserati are rooted in Europe. The rest of the Stellantis brands (like Opel, Lancia, and Citroen) are not distributed in America. Nothing is official, and the publication stressed it's unclear whether Dodge will commit part- or full-time to the series (assuming the program receives the green light). Finot underlined the parallel car would use the 9X8's "spine," so don't expect to see a Peugeot hypercar with a Dodge emblem driving flat-out on the Sebring International Raceway.

Dodge Demon test mule spotted wearing unusual camouflage

The Dodge Demon apparently refuses to stay under wraps. The endless rollout of teasers continues each Thursday, but thanks to both Vin Diesel and our trusty spy photographer we have a whole suite of photos that show a nearly complete car in the flesh. This car appears to have been hiding in plain sight, as some of these photos were captured in the Detroit area. The car or cars in these photos is far less polished than the one shown in all of Dodge's teasers. The Air Grabber hood is unpainted, though it does come with some awesome hood pins. The same goes for the bolt-on fenders, as other pictures show a cleaner integration of the Demon's widebody modification. Despite the large Nitto logo on the top of the windshield, the cars in these photos are both wearing a set of Pirelli PZero All-season Plus tires on non-Demon wheels. It's as if drag radials aren't the best choice for winter driving. This car is fitted with two-piece Brembo brakes, but there's no telling if they're different than the standard Hellcat's. The decals on the side of the car may give clues to some of the Demon's equipment, but based on the LB Performance - commonly known as Liberty Walk- logo, the decals are likely more of a ruse than anything else. Liberty walk is famous in the tuning community for big, bolt-on body kits. The looks perfectly suit these test cars, though Borla exhaust and a Hurst shifter would be a wonderful addition to the Demon. Outside of that, there isn't much new to glean from these photos. Most of our questions about the Demon (horsepower, gearing, price) can't be had from pictures. Look for more news each Thursday in the lead up to the car's debut in New York in April. Related Video: Featured Gallery Dodge Demon Spy Shots View 14 Photos Related Gallery Dodge Demon Teasers View 17 Photos Image Credit: KGP Photography Spy Photos Dodge Coupe dodge hellcat