2011 Dodge Grand Caravan Mainstreet on 2040-cars

Auto blog

Dodge Journey and Fiat Freemont engine-cover recall affects 350k CUVs

FCA is recalling 349,731 examples of the 2011-2015 Dodge Journey and Fiat Freemont worldwide to better secure their engine covers. Of these affected vehicles, there are 144,416 in the US, 43,679 in Canada, 46,231 in Mexico, and 115,405 elsewhere. About 10 percent of them are also still at dealers, according to the automaker. Only models with the 2.4-liter four-cylinder engine are affected by this campaign. According to the company, the engine covers on these vehicles can be dislodged, and this can pose a fire risk if the loose part comes in contact with hot exhaust components. Warning signs of this happening include a noise under the hood, burning smell or a light on the instrument panel. The problem was discovered after three incidents on rough roads in Chile, and there was one minor injury there. According to FCA US spokesperson Eric Mayne to Autoblog, there have been eight occurrences of this issue reported in the US, but these were all related to "heat damage." There have been no reported injuries here. To fix the problem, dealers will install new engine-cover retainers on the affected models. These repairs will begin in August. As always for recall repairs, owners won't be charged. Statement: Engine Cover July 22, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 144,416 crossover utility vehicles (CUVs) in the U.S. to better secure their engine covers. Engine covers in certain vehicles may become dislodged. If they come in contact with exhaust components, it may pose a fire risk. This condition was discovered during an FCA US investigation of three incidents in Chile. In each case, the vehicle had been driven extensively on unpaved or uneven surfaces. The Company is aware of a single related injury, described as minor. Affected are 2011-2015 Dodge Journey and Fiat Freemont CUVs equipped with 2.4-liter, four-cylinder engines. FCA US will install upgraded engine-cover retainers in these vehicles. The remedy will be available when customer notification begins next month; service will be performed free of charge. Vehicles equipped with six-cylinder engines are not affected. Additional Journey and Freemont populations also are subject to this campaign. They comprise an estimated 43,679 vehicles in Canada; 46,231 in Mexico; and 115,405 outside the NAFTA region. Of the 349,731 total vehicles subject to this campaign, approximately 10 percent remain in dealer hands.

The last time Dodge recycled the Demon name, it was for a Miata fighter

We and the rest of the automotive world are eagerly awaiting the reveal of the Dodge Challenger Demon. And why wouldn't we be? It's going to be a Hellcat, but with less weight, bigger fenders, more performance, and more Vin Diesel. This isn't the first time we've been excited about a Demon from Dodge, though. Ten years ago, Dodge had another demonic car, but it was very different from the new one. The Demon of 2007 was a lithe little roadster that looked primed and ready to take on the Miata, as well as the now-departed Solstice and Sky twins. The Demon was just under an inch shorter than the MX-5 and the Solstice, and it packed a 172 horsepower 2.4-liter four-cylinder that fell right between the Miata's 170 and the Solstice's 177 outputs. Dodge's estimated the curb weight, which for a concept is largely theoretical, also slotted between the two cars at 2600 pounds. That was about 150 more than the Mazda, and about 200 less than the Pontiac. The pitch perfect specifications were presented in a crisp two-seat roadster wrapper. In many ways, it looked like a baby Viper, with a menacing crosshair grille, slanted headlights, and fat rear fenders. The Demon's line's were brutally simple and geometric, too. They didn't seem far removed from the first-generation Audi TT. The interior was also plain and simple. The key highlights were a horizontal aluminum accent that ran the width of the dash, echoed by an aluminum-covered center console. The instrument cluster was uncluttered, with just four gauges, and the only controls were some climate knobs, a double-DIN head unit, and a six-speed manual. It turns out that the 2007 Demon didn't drive very well, though. You see, we actually drove this concept back in the day, and like many concepts, it still had a long way to go to be production ready. The gearbox would grind, the ride quality was terrible. However, the interior was roomy, and the engine sounded suitably grumbly, if a bit coarse. At the time, we said Dodge should absolutely build the little roadster. In retrospect, the company probably made the right decision not to invest in the Demon. The small rear drive sports car segment was, and still is, an extremely niche market. It would have been a big investment for little return, something FCA today is trying to avoid. This is all before taking into account the fact that the recession was just around the corner. In the end, we can't be too sad though.

Dodge revives Challenger T/A and Charger Daytona trims for 2017

Dodge is reviving the Challenger's T/A trim and the Charger's Daytona line for 2017. Introduced on iconic Woodward Avenue just days before the annual Woodward Dream Cruise kicks off, the new variants promise more performance hardware and sportier aesthetics. We'll start with the two-door. The Challenger T/A, available with either the R/T trim's 5.7-liter V8 or the fire-breathing 6.4-liter Hemi V8, is inspired by the Challenger T/As of old. That means a less restrictive, 2.75-inch active exhaust system and a conical Mopar air filter. But there's no clear bump in output – Dodge still lists the base 5.7-liter at 375 horsepower and the 6.4-liter model at 485 hp. But hey, they're going to look cooler. Unlike the Challenger Hellcat, which should have it as standard, Dodge is including a Satin Black hood on every Challenger T/A. In fact, Satin Black is a recurring theme on this Challenger's front fascia, roof, rear decklid, and T/A bodyside stripes. And yes, the 20-inch Mopar wheels are black, too – they're also an inch wider than normal. Dodge is offering the T/A in three different trims. The base T/A has everything we described above, while the T/A Plus adds some comfort features like heated and vented Nappa leather seats, an 8.4-inch UConnect system with Apple CarPlay/Android Auto, a six-speaker stereo, and a shortcut button for the Dodge Performance Pages. The T/A 392, meanwhile, adds the 6.4-liter V8, even wider wheels, and Brembo six-pot calipers. If you prefer smoking tires with four doors, there's the new Charger Daytona. No, there's not an enormous wing on the back. But Dodge added the same kind of engine/exhaust upgrades found on the T/A while upping the top speed from 135 to 150 miles per hour. Satin Black features prominently again, with hood and rear fender graphics. The roof is also black. Unlike the Challenger, Dodge is only offering two different versions of the Daytona – the 5.7-liter base model and the 6.4-liter version, called the Daytona 392. Prices for the Challenger T/A start at $38,485, including a $1,095-destination charge, while the T/A Plus adds $2,750. Adding the 392 means shelling out $45,090. For the Daytona, you'll need a check for $40,985 for the 5.7-liter or $46,090 for the 6.4-liter. Orders for the Charger Daytona open in September, while the T/A is a month later. Related Video: