Find or Sell Used Cars, Trucks, and SUVs in USA

1968 Dodge Dart Slant Six on 2040-cars

Year:1968 Mileage:94000 Color: Blue /
 Brown
Location:

Port Jefferson Station, New York, United States

Port Jefferson Station, New York, United States
Advertising:
Transmission:Automatic
Body Type:Sedan
Engine:slant six 225/3.7
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
Year: 1968
Interior Color: Brown
Make: Dodge
Number of Cylinders: 6
Model: Dart
Trim: four door.
Drive Type: automatic RWD
Mileage: 94,000
Exterior Color: Blue
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"1968 dodge darthas some rust in the quart panels, fenders etc, interior was redone a few years ago.car runs and drives;just had new spark plugsthermostatintake manifold and exhaust manifold gasketfuel pumpcap, rotor , linesjust rebuilt carburetortheres a few bondo'd areas on the car that can be seen in the photoseverything on the car works,right taillight bezel is crackedright rear quarter panel has dentfront right fender has dent- (this fender is from a 1969)i have the trim pieces that belong on that fenderdent on trunk"

1968 dodge dart four door
slant six motor 225/3.7

great project car

has some rust in the quart panels, fenders etc, the car is from 1968


interior was redone a few years ago.

car runs and drives has not been on the road since 2008

just replaced
 
spark plugs
thermostat
intake manifold and exhaust manifold gasket
fuel pump
cap, rotor , lines
just rebuilt carburetor


theres a few bondo'd areas on the car that can be seen in the photos

everything on the car works,
right taillight bezel is cracked

right rear quarter panel has dent
front right fender has dent- (this fender is from a 1969)
i have the trim pieces that belong on that fender
dent on trunk


comes with another set of wheels.
not sure if they fit the car

Located in long island NY

serious inquiries may call or text 631-880-9686 at any time to discuss vehicle


LOCAL PICKUP only

will only deal with shipping if i speak with buyer on the phone at the number above


Auto Services in New York

Whitesboro Frame & Body Svc ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Wheels-Aligning & Balancing
Address: 1430 Lincoln Ave, Washington-Mills
Phone: (315) 735-6360

Used-Car Outlet ★★★★★

Used Car Dealers
Address: East-Rochester
Phone: (585) 645-8895

US Petroleum ★★★★★

Auto Repair & Service
Address: 465 Nassau Ave, Roosevelt
Phone: (929) 224-0634

Transitowne Misibushi ★★★★★

New Car Dealers, Used Car Dealers
Address: 7428 Transit Rd, Lockport
Phone: (716) 634-9000

Transitowne Hyundai ★★★★★

New Car Dealers, Used Car Dealers
Address: 7420 Transit Rd, Lockport
Phone: (716) 634-3000

Tirri Motor Cars ★★★★★

Automobile Parts & Supplies, Automobile Accessories
Address: 1 Orange Ave, Suffern
Phone: (845) 533-4400

Auto blog

1985 Dodge Omni GLH | eBay Find of the Day

Thu, Mar 7 2019

Cars from the 1980s weren't exactly known for performance. The muscle car days had ended a decade prior, and computer controls and precision engineering standards were still in their infancy. But that doesn't mean the decade was a complete loss for automotive enthusiasts. For proof, take a look at this 1985 Dodge Omni GLH that's currently for sale on eBay. Carroll Shelby's affiliation with Ford was in hiatus (and under litigation in court), but the legendary tuner wasn't content to sit around and do nothing. Shelby turned to Dodge right around the time that the American company was dipping its toes into turbocharging. The partnership led to several interesting vehicles, but perhaps none of them were as unexpected as the Shelby-modified Omni hatchback. The '85 GLH you see above is powered by a turbocharged 2.2-liter four-cylinder engine that sends 146 horsepower to the front wheels through a five-speed manual transmission. These days, that might not sound like a lot of power. But when you consider that the base LG4-code 305-cubic-inch V8 in the Chevy Camaro Z28 spun out 155 hp that same year, you start to understand why the Shelby Omni was a big deal. Suspension changes to the Omni GLH included stiffer springs, firmer shocks, and a lowered ride height that dropped the bodywork closer to its 15-inch aluminum wheels. GLH badging — which, in true Shelby fashion stood for "Goes Like Hell" — and blacked-out bodywork rounded out the updates. Dodge sold 6,513 Omni GLH models in 1985, and just 3,509 were equipped with the turbocharged engine. You'll have to look long and hard to find one that's nicer than this on eBay. The seller claims it's mostly in original condition, and its low odometer reading of 15,901 miles seems to back that up. It's located in Wixom, Michigan, with an asking price of $18,900.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Sun, Aug 11 2024

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Fiat Chrysler profit up as it closes in on retiring its debt

Thu, Apr 26 2018

MILAN — Fiat Chrysler Automobiles reduced its debt by more than expected in the first quarter, putting the carmaker well on course to become cash positive later this year. Chief Executive Sergio Marchionne expects to cancel all debt during 2018 — possibly by the end of June — and generate around 4 billion euros ($5 billion) in net cash by the end of the year. Marchionne has said that forecast does not include any one-off measures, nor the impact of the planned spinoff of parts maker Magneti Marelli, which he hopes to execute by early 2019. The world's seventh-largest carmaker said on Thursday net debt had fallen to 1.3 billion euros ($1.6 billion) by the end of March, well below a consensus forecast of 2.6 billion euros in a Thomson Reuters poll of analysts. FCA said capital spending fell 900 million euros in the quarter due to "program timing," which analysts said implied higher investments for the rest of the year. The Italian-American group said first-quarter operating profit rose 5 percent to 1.61 billion euros, below a consensus forecast of 1.74 billion, as a weaker performance from its North American profit center weighed. Shipments there were higher due to the new Jeep Wrangler and Compass models. But currency moves hit revenues and earnings, and costs related to new product launches added to the pressure. FCA's shift to sell more trucks and SUVs boosted margins yet again in North America to 7.4 percent from 7.3 percent in the same quarter a year ago, although they were down from the 8 percent recorded in the preceding three months. Marchionne, preparing to hand over to an internal successor next year, is close to his goal of ending a margin gap with larger U.S. rivals General Motors and Ford. The 65-year-old has said becoming debt free and being able to compete on a par with U.S. peers would mean FCA no longer needed a partner to survive and could well succeed on its own. The CEO has previously said tying up with another carmaker would help to meet the huge costs in an industry investing in electric vehicles and automated driving. FCA shares fell immediately after the results, but recovered to trade up 3 percent at 19.71 euros by 1150 GMT, outperforming a 0.4 percent rise in Europe's blue-chip stock index. ($1 = 0.8214 euros) Reporting by Agnieszka FlakRelated Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.