2000 Dodge Dakota Sport Edition 4x4, Ext Cab,85,xxx Original Miles, Must See on 2040-cars

Auto blog

Ford, Stellantis workers join those at GM in ratifying contract that ended UAW strikes

DETROIT — The United Auto Workers union overwhelmingly ratified new contracts with Ford and Stellantis, that along with a similar deal with General Motors will raise pay across the industry, force automakers to absorb higher costs and help reshape the auto business as it shifts away from gasoline-fueled vehicles. Workers at Stellantis, the maker of Jeep, Dodge and Ram vehicles, voted 68.8% in favor of the deal. Their approval brought to a close a contentious labor dispute that included name-calling and a series of punishing strikes that imposed high costs on the companies and led to significant gains in pay and benefits for UAW workers. The deal at Stellantis passed by a roughly 10,000 vote margin, with ballot counts ending Saturday afternoon. Workers at Ford voted 69.3% in favor of the pact, which passed with nearly a 15,000-vote margin in balloting that ended early Saturday. Earlier this week, GM workers narrowly approved a similar contract. The agreements, which run through April 2028, will end contentious talks that began last summer and led to six-week-long strikes at all three automakers. Shawn Fain, the pugnacious new UAW leader, had branded the companies enemies of the UAW who were led by overpaid CEOs, declaring the days of union cooperation with the automakers were over. After summerlong negotiations failed to produce a deal, Fain kicked off strikes on Sept. 15 at one assembly plant at each company. The union later extended the strike to parts warehouses and other factories to try to intensify pressure on the automakers until tentative agreements were reached late in October. The new contract agreements were widely seen as a victory for the UAW. The companies agreed to dramatically raise pay for top-scale assembly plant workers, with increases and cost-of-living adjustments that would translate into 33% wage gains. Top assembly plant workers are to receive immediate 11% raises and will earn roughly $42 an hour when the contracts expire in April of 2028. Under the agreements, the automakers also ended many of the multiple tiers of wages they had used to pay different workers. They also agreed in principle to bring new electric-vehicle battery plants into the national union contract. This provision will give the UAW an opportunity to unionize the EV battery plants plants, which will represent a rising share of industry jobs in the years ahead.

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Dodge Viper returning to Le Mans this year?

If you were among the fans disappointed by Chrysler's recent decision to end the Dodge Viper's racing program, we may have some good news for you, as the racing outfit behind the campaign is reportedly working to bring the American supercars back to Le Mans this year. That racing outfit is Riley Technologies, a constructor perhaps best known for its Daytona Prototypes, but it has also prepared its share of GT racers, too. Chrysler charged Riley with leading its racing program for the new Viper GTS-R, campaigned it in the United SportsCar Championship and the 24 Hours of Le Mans. Auburn Hills made the unfortunate decision back in March to pull its Vipers out of Le Mans, and then in October to withdraw from the US series, as well, thereby effectively ending the program altogether. Disappointed though it surely was, Riley remains defiant. The North Carolina-based company is planning on taking the existing Vipers back to Le Mans on its own, with or without factory support. The Viper has, after all, proven a capable machine, having taken both the drivers' and teams' titles in the United SportsCar Championship this past season. "With Le Mans, every driver and every manufacturer needs to have their first trip there, and it isn't always what you want it to be, but we did show reliability and did have some pace," Bill Riley told Racer.com. "Since then, we've worked hard on the cars, they're now strong, front-running cars in the US, and we're working with the ACO on the BoP to make sure the cars are strong at Le Mans. They're super-reliable and fast, and we'd expect to be right in the mix with the other cars." Riley has kept the existing support staff in place, and once it secures its driver lineup and sponsors, chances look good that it could represent America well at Le Mans this year in either the GTE Pro or GTE Am class. Its predecessor did, after all, complete a three-year winning streak that saw it dominate the GTS class right up until its withdrawal in 2000. News Source: Racer.comImage Credit: FCA Motorsports Dodge Coupe Racing Vehicles